IEC 60567-2005 充油电气设备.分析游离气体和溶解气体用气体和油的取样.指南.pdf

标准号：IEC 60567-2005
实施状态：作废
中文名称：充油电气设备.分析游离气体和溶解气体用气体和油的取样.指南
英文名称：Oil-filled electrical equipment - Sampling of gases and of oil for the analysis of free and dissolved gases - Guidance
发布日期：2005-06
被替代标准：IEC 60567-2011
代替标准：IEC 10/621/FDIS-2005;IEC 60567-1992
采用标准：DIN EN 60567-2006,IDT;BS EN 60567-2005,IDT;EN 60567-2005,IDT;NF C27-224-2006,IDT;OEVE/OENORM EN 60567-2006,IDTN-EN 60567-2006,IDT;UNE-EN 60567-2006,IDT
起草单位：IEC/TC 10
标准简介：This International Standard deals with the techniques for sampling free gases from gas-collecting relays and for sampling oil from oil-filled equipment such as power and instrument transformers, reactors, bushings, oil-filled cables and oil-filled tank-type capacitors. Three methods of sampling free gases and three methods of sampling oil are described; the choice between the methods often depends on the apparatus available and on the quantity of oil needed for analysis.
Before analysing the gases dissolved in oil, they must first be extracted from the oil. Three basic methods are described, one using extraction by vacuum (Toepler and partial degassing), another by displacement of the dissolved gases by bubbling the carrier gas through the oil sample (stripping), and the last one by partition of gases between the oil sample and a small volume of the carrier gas (head space). The gases are analysed quantitatively after extraction by gas chromatography; a method of analysis is described. Free gases from gas-collecting relays are analysed without preliminary treatment.
The preferred method for assuring the performance of the gas extraction and analysis equipment, considered together as a single system, is to degas samples of oil prepared in the laboratory and containing known concentrations of gases ("gas-in-oil standards") and quantitatively analyse the gases extracted. Two methods of preparing gas-in-oil standards are described.
For daily calibration checks of the chromatograph, it is convenient to use a standard gas mixture containing a suitable known amount of each of the gas components to be in a similar ratio to the commons ratios of the gases extracted from transformer oils.
The techniques described take account, on the one hand, of the problems peculiar to analyses associated with acceptance testing in the factory, where gas contents of oil are generally very low and, on the other hand, of the problems imposed by monitoring equipment in the field, where transport of samples may be by un-pressurized air freight and where considerable differences in ambient temperature may exist between the plant and the examining laboratory.
文件格式：PDF
文件大小：2.43MB
文件页数：136
（以上信息更新时间为：2019-11-25）



文档语言及版本参照下方封面截图：