CEN_TS 16675-2014 废物特性.测定废弃物整体状态的测定方法.pdf

标准号：CEN/TS 16675-2014
实施状态：现行
中文名称：废物特性.测定废弃物整体状态的测定方法
英文名称：Characterisation of waste - Test methods for the determination of the monolithic status of waste
发布日期：2014-09
代替标准：FprCEN/TS 16675-2013
采用标准：DIN CEN/TS 16675-2014,IDTD CEN/TS 16675-2014,IDT;XP X30-493-2014,IDT;ONR CEN/TS 16675-2014,IDT;SIS-CEN/TS 16675-2014,IDT;TSE CEN/TS 16675-2014,IDT;DS/CEN/TS 16675-2014,IDT;CEN/TS 16675:en-2014,IDT;CEN/TS 16675:2014 en-2014,IDT;UNI CEN/TS 16675:2014-2014,IDT;STN P CEN/TS 16675-2016,IDT;CSN P CEN/TS 16675-2015,IDT;DS/CEN/TS 16675-2014,IDT
标准简介：This Technical Specification provides methods, which can be used to assess the monolithic character of a stabilised/solidified waste, with respect to landfilling. Information on the monolithic character is required to enable the choice of appropriate leaching tests for determination of the release of different substances from stabilised/solidified waste under specified (landfilling) conditions. This document includes several physical and/or chemical test methods each addressing different aspects of monolithic character. The selection of methods required for an assessment of the monolithic character of a stabilised/solidified waste may vary, depending on the scenario to be addressed or it may be specified in regulation. Rather than describing the procedures and methods in detail this document refers to existing standards and provides some guidance on their use on stabilised/solidified waste materials. This Technical Specification does not address issues related to health and safety. The following procedures and methods are included in this document: test to determine unconfined compressive strength; - test to determine permeability; - test to determine the loss of mass by dissolution or disintegration; - test to determine expansion; - test to determine the content of organic matter; - test to determine freeze/thaw effects.
文件格式：PDF
文件大小：975.10KB
文件页数：16
（以上信息更新时间为：2019-11-28）



文档语言及版本参照下方封面截图：