EN 13381-1-2014 对结构部件耐火性作用的检测方法.第1部分_水平保护膜.pdf

标准号：EN 13381-1-2014
实施状态：现行
中文名称：对结构部件耐火性作用的检测方法.第1部分:水平保护膜
英文名称：Test methods for determining the contribution to the fire resistance of structural members - Part 1: Horizontal protective membranes
发布日期：2014-09
代替标准：CEN/TS 13381-1-2005;FprEN 13381-1-2014
采用标准：DIN EN 13381-1-2014,IDT;BS EN 13381-1-2014,IDT;NF P92-140-1-2014,IDT;SN EN 13381-1-2014,IDT;OENORM EN 13381-1-2014,IDTN-EN 13381-1-2014,IDTN-EN 13381-1-2016,IDT;SS-EN 13381-1-2014,IDT;UNE-EN 13381-1-2016,IDT;TS EN 13381-1-2015,IDT;DS/EN 13381-1-2015,IDT;UNI EN 13381-1:2014-2014,IDT;STN EN 13381-1-2015,IDT;CSN EN 13381-1-2014,IDT;DS/EN 13381-1-2015,IDT;NEN-EN 13381-1:2014 en-2014,IDT;SFS-EN 13381-1:en-2014,IDT
标准简介：This European Standard specifies a test method for determining the ability of a horizontal protective membrane, when used as a fire resistant barrier, to contribute to the fire resistance of standard horizontal structural building members as defined in 6.4.2. Test of horizontal protective membrane installed under a specific non-standard floor should be tested according to EN 1365-2. This European Standard contains the fire test which specifies the tests which are carried out whereby the horizontal protective membrane, together with the structural member to be protected, is exposed to a fire test according to the procedures defined herein. The fire exposure, to the temperature/time curve given in EN 1363-1, is applied from below the membrane itself. The test method makes provision, through specified optional additional procedures, for the collection of data which can be used as direct input to the calculation of fire resistance according to the processes given within EN 1992-1-2, EN 1993-1-2, EN 1994-1-2 and EN 1995-1-2. This European Standard also contains the assessment which provides information relative to the analysis of the test data and gives guidance for the interpretation of the results of the fire test, in terms of loadbearing capacity criteria of the protected horizontal structural member. In special circumstances, where specified in national building regulations, there can be a need to subject the protection material to a smouldering curve. The test for this and the special circumstances for its use are detailed in Annex C. The limits of applicability of the results of the assessment arising from the fire test are defined, together with permitted direct application of the results to different structures, membranes and fittings. This European Standard applies only where there is a gap and a cavity between the horizontal protective membrane and the structural building member. Otherwise, the test methods in prEN 13381-3, EN 13381-4 or prEN 13381-5, as approp
文件格式：PDF
文件大小：1.88MB
文件页数：52
（以上信息更新时间为：2019-11-28）



文档语言及版本参照下方封面截图：