IEC 62091-2007 低压开关设备和控制器.固定消防泵启动的控制器.pdf

标准号：IEC 62091-2007
实施状态：现行
中文名称：低压开关设备和控制器.固定消防泵启动的控制器
英文名称：Low-voltage switchgear and controlgear - Controllers for drivers of stationary fire pumps
发布日期：2007-01
代替标准：IEC 17B/1527/FDIS-2006;IEC/TS 62091-2003
采用标准：GB/T 21208-2007,MOD;C63-830PR,IDT
起草单位：IEC/SC 17B
标准简介：This International Standard applies to controllers intended for starting, controlling and
stopping stationary fire pumps, including automatic and non-automatic types for alternating
current electric motor or diesel engine-driven fire pumps. It is anticipated that a controller only
controls a single driver.
Controllers for electric motor-driven fire pumps always include suitable short-circuit protection
as an integral part of the controller. These controllers may include an integral power transfer
switch. These controllers are rated 1 000 V a.c. maximum.
Controllers for diesel engine-driven fire pumps include electrical circuits that operate various
control and supervisory functions, such as remote control (starting), alarms, signals,
indicators, and the proper operation of battery chargers.
The most significant purpose of this standard is to characterize the unique features of fire
pump controllers. A further purpose is to prescribe a procedure for exercising the controllers
to verify that the unique features are operative. For the purpose of this standard, this
procedure is described as the “fire pump controller test protocol”.

The requirements of this standard apply neither to the method nor to the means by which the
electrical energy is generated. In addition, they do not apply to the installation between the
origin of the installation and the fire pump controller, which are to be found in the IEC 60364
series. This standard does not apply to diesel engine-driven electric generators which may be
associated with a stationary fire pump installation.
文件格式：PDF
文件大小：680.32KB
文件页数：124
（以上信息更新时间为：2019-11-25）



文档语言及版本参照下方封面截图：