IEC 61000-6-3-2006 电磁兼容性.第6-3部分_总标准.住宅区、商业区和轻工业环境的辐射标准.pdf

标准号：IEC 61000-6-3-2006
实施状态：现行
中文名称：电磁兼容性.第6-3部分:总标准.住宅区、商业区和轻工业环境的辐射标准
英文名称：Electromagnetic compatibility (EMC) - Part 6-3: Generic standards - Emission standard for residential, commercial and light-industrial environments
发布日期：2006-07
代替标准：CISPR/H/121/FDIS-2006;IEC 61000-6-3-1996
采用标准：DIN EN 61000-6-3-2007,IDT;BS EN 61000-6-3-2007,IDT;EN 61000-6-3-2007,IDT;NF C91-006-3-2007,IDT;OEVE/OENORM EN 61000-6-3-2007,IDTN-EN 61000-6-3-2007,IDTN-EN 61000-6-3-2008,IDT;UNE-EN 61000-6-3-2007,IDT;GOST R 51317.6.3-2009,IDT
起草单位：IEC
标准简介：This part of IEC 61000 for EMC emission requirements applies to electrical and electronic apparatus intended for use in residential, commercial and light-industrial environments.
Emission requirements in the frequency range 0 Hz to 400 GHz are covered. No measurement needs to be performed at frequencies where no requirement is specified.
This generic EMC emission standard is applicable if no relevant dedicated product or product-family EMC emission standard exists.
This standard applies to apparatus intended to be directly connected to a low-voltage public mains network or connected to a dedicated DC source, which is intended to interface between the apparatus and the low-voltage public mains network. This standard applies also to apparatus which is battery operated or is powered by a non-public, but non-industrial, low-voltage power distribution system if this apparatus is intended to be used in the locations described below.
The environments encompassed by this standard are residential, commercial and light-industrial locations, both indoor and outdoor. The following list, although not comprehensive, gives an indication of locations that are included:
-    residential properties, for example houses, apartments;
-    retail outlets, for example shops, supermarkets;
-    business premises, for example offices, banks;
-    areas of public entertainment, for example cinemas, public bars, dance halls;
-    outdoor locations, for example petrol stations, car parks, amusement and sports centres;
-    light-industrial locations, for example workshops, laboratories, service centres.
Locations that are characterised by being supplied directly at low voltage from the public mains network are considered to be residential, commercial or light-industrial.
The object of this standard is to define the emission test requirements for apparatus defined in the scope in relation to continuous and transient, conducted and radiated disturbances.
The emission requirements have been selected so as to ensure that disturbances generated by apparatus operating normally in residential, commercial and light-industrial locations do not exceed a level which could prevent other apparatus from operating as intended. Fault conditions of apparatus are not taken into account. Not all disturbance phenomena have been included for testing purposes in this standard but only those considered as relevant for the equipment covered by this standard. These requirements represent essential electromagnetic compatibility emission requirements.
文件格式：PDF
文件大小：513.84KB
文件页数：36
（以上信息更新时间为：2019-11-25）



文档语言及版本参照下方封面截图：