ISO 7919-2-2009 机械振动.通过在旋转轴上的测量评价机械振动.第2部分_功率超过50MW、额定转速在1500r_min、1800 r_min、3000 r_min和3600 r_min的地面安装的蒸汽轮机和发电机组.pdf

标准号：ISO 7919-2-2009
实施状态：作废
中文名称：机械振动.通过在旋转轴上的测量评价机械振动.第2部分:功率超过50MW、额定转速在1500r/min、1800 r/min、3000 r/min和3600 r/min的地面安装的蒸汽轮机和发电机组
英文名称：Mechanical vibration - Evaluation of machine vibration by measurements on rotating shafts - Part 2: Land-based steam turbines and generators in excess of 50 MW with normal operating speeds of 1500 r/min, 1800 r/min, 3000 r/min and 3600 r/min
发布日期：2009-10
被替代标准：ISO 20816-2-2017
代替标准：ISO 7919-2-2001;ISO/DIS 7919-2-2009
采用标准：DIN ISO 7919-2-2010,IDT;BS ISO 7919-2-2009,IDT;GB/T 11348.2-2012,MOD;NF E90-079-2-2010,IDT;SS-ISO 7919-2-2009,IDT;KS B ISO 7919-2-2013,IDT;GOST R 55263-2012,IDT;UNI ISO 7919-2-2010-2010,IDT;CSN ISO 7919-2-2010,IDT;NEN-ISO 7919-2-2009 en-2009,IDT;SFS-ISO 7919-2-en-2012,IDT
起草单位：ISO/TC 108
标准简介：This part of ISO 7919 establishes provisions for evaluating the severity of in-situ, broad-band shaft vibration
measured radial (i.e. transverse) to the shaft axis at, or close to, the main bearings. These are in terms of:
⎯ vibration under normal steady-state operating conditions;
⎯ vibration during other (non-steady-state) conditions when transient changes are taking place, including
run up or run down, initial loading and load changes;
⎯ changes in vibration which can occur during normal steady-state operation.
This part of ISO 7919 is applicable to land-based steam turbines and generators with power outputs greater
than 50 MW and a normal operating speed of 1 500 r/min, 1 800 r/min, 3 000 r/min or 3 600 r/min. It is also
applicable to steam turbines and/or generators which are directly coupled to a gas turbine (such as for
combined-cycle applications). In such cases, the criteria of this part of ISO 7919 apply only to the steam
turbine and the generator (including synchronizing clutches). ISO 7919-4 and ISO 10816-4 are applicable to
the evaluation of the gas turbine vibration.
The numerical values specified are not intended to serve as the only basis for judging the severity of vibration.
For large steam turbines and generators, it is also common to judge the vibration based on measurements
taken on non-rotating parts. For such vibration measurement requirements, see ISO 10816-1 and
ISO 10816-2.
文件格式：PDF
文件大小：128.26KB
文件页数：20
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：