ISO 13506-2008 防热和防火防护服.完整服装的试验方法.用装备仪器的假人对燃烧伤害的预测.pdf

标准号：ISO 13506-2008
实施状态：作废
中文名称：防热和防火防护服.完整服装的试验方法.用装备仪器的假人对燃烧伤害的预测
英文名称：Protective clothing against heat and flame - Test method for complete garments - Prediction of burn injury using an instrumented manikin
发布日期：2008-05
被替代标准：ISO 13506-1-2017;ISO 13506-2-2017
代替标准：ISO/FDIS 13506-2008
采用标准：DIN ISO 13506-2008,IDT;ABNT NBR ISO 13506-2016,IDT;BS ISO 13506-2008,IDT;KS K ISO 13506-2010,IDT
起草单位：ISO/TC 94
标准简介：This International Standard provides the general principles of a test method for evaluating the performance of
complete garments or protective clothing ensembles in a flash fire or other short duration exposures. This test
method characterizes the thermal protection provided by garments, based on the measurement of heat
transfer to a full-size manikin exposed to a laboratory simulation of a fire with controlled heat flux density,
duration and flame distribution. The heat transfer measurements can also be used to calculate the predicted
skin burn injury resulting from the exposure. In addition, observations are recorded on the overall behaviour of
the test specimen during and after the exposure.
This method is useful for three types of evaluation:
a) comparison of garment or ensemble materials;
b) comparison of garment or ensemble design; and
c) evaluation of any garment or ensemble prototype for a particular application or to a specification.
Each type of evaluation has different garment or ensemble requirements because the test results are
dependent on the test material performance, on the garment size, on the garment design and on the use of
ensemble components.
The results obtained apply only to the particular garments or ensembles, as tested, and for the specified
conditions of each test, particularly with respect to the heat flux density, duration and flame distribution. For
the purposes of this test method, the incident heat flux density is limited to a nominal level of 84 kW/m2.
This International Standard is intended to be used to measure and describe the behaviour of complete
garments or protective clothing ensembles in response to convective and radiant energy under controlled
laboratory conditions, with the results used to optimize garment combinations and designs. This International
Standard is not intended to be used to compare the properties of garment materials or combinations of
materials unless the test specimens are absolutely identical in size and design. Furthermore, this International
Standard is not intended to be used to describe or appraise the fire hazard or fire risk under actual fire
conditions. However, the results of this test can be used as elements of a fire risk assessment which takes
into account all of the factors that are pertinent to an assessment of the fire hazard of a particular end use.
Considerations for the use of this test method are provided in Annex A. Inter-laboratory data for the test
method are provided in Annex B.
文件格式：PDF
文件大小：534.90KB
文件页数：36
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：