ISO 2285-2007 硫化橡胶或热塑性橡胶.在恒定延伸率条件下测定拉伸永久变形、和在恒定拉伸载荷下测定拉伸永久变形、伸长率和蠕变.pdf

标准号：ISO 2285-2007
实施状态：作废
中文名称：硫化橡胶或热塑性橡胶.在恒定延伸率条件下测定拉伸永久变形、和在恒定拉伸载荷下测定拉伸永久变形、伸长率和蠕变
英文名称：Rubber, vulcanized or thermoplastic - Determination of tension set under constant elongation, and of tension set, elongation and creep under constant tensile load
发布日期：2007-07
被替代标准：ISO 2285-2013
代替标准：ISO 2285-2001;ISO/FDIS 2285-2007
采用标准：DIN ISO 2285-2010,IDT;DIN ISO 2285-2009,IDT;BS ISO 2285-2007,IDT;NF T46-009-2007,IDT;UNE-ISO 2285-2009,IDT
起草单位：ISO/TC 45
标准简介：This International Standard specifies a number of methods of determining the dimensional changes in test pieces of vulcanized or thermoplastic rubber during and after tensile loading for relatively short periods under constant elongation or constant loading.
The constant-elongation test is intended to measure the ability of rubbers to retain their elastic properties after extension,at a standard laboratory temperature, to a specifies strain which is remained for a specified time at the same or at a specified higher temperature and then released at the test temperature or at the standard laboratory temperature.
The constant-load test specifies a method for the determination of elongation,creep and tension set of rubbers subjected to a constant load at standard laboratory temperature.
The test methods are intended to measure the elastic properties of rubber in the hardness range 20 IRHD to 94 IRHD.
The creep measurement is not recommended for product design or the evaluation of low-creep materials.For these,reference should be made to ISO 8013.No agreement between the results of this test or those of ISO 8013 should be inferred.
文件格式：PDF
文件大小：177.25KB
文件页数：16
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：