ISO 8178-1-2006 往复式内燃机.废气排放测量.第1部分_排气和颗粒废物排放量现场测量.pdf

标准号：ISO 8178-1-2006
实施状态：作废
中文名称：往复式内燃机.废气排放测量.第1部分:排气和颗粒废物排放量现场测量
英文名称：Reciprocating internal combustion engines - Exhaust emission measurement - Part 1: Test-bed measurement of gaseous and particulate exhaust emissions
发布日期：2006-09
被替代标准：ISO 8178-1-2017
代替标准：ISO 8178-1-1996;ISO/FDIS 8178-1-2006
采用标准：ABNT NBR ISO 8178-1-2012,IDT;BS ISO 8178-1-2009,IDT;GB/T 8190.1-2010,IDT;NF E37-211-1-2006,IDT;JIS B 8008-1-2009,MOD;GOST ISO 8178-1-2013,IDT;TS ISO 8178-1-2014,IDT;TS ISO 8178-1-2015,IDT
起草单位：ISO/TC 70
标准简介：This part of ISO 8178 specifies the measurement and evaluation methods for gaseous and particulate exhaust
emissions from reciprocating internal combustion (RIC) engines under steady-state conditions on a test bed,
necessary for determining one weighted value for each exhaust gas pollutant. Various combinations of engine
load and speed reflect different engine applications (see ISO 8178-4).
This part of ISO 8178 is applicable to RIC engines for mobile, transportable and stationary use, excluding
engines for motor vehicles primarily designed for road use. This part of ISO 8178 may be applied to engines
used, for example, for earth-moving machines, generating sets and for other applications.
In limited instances, the engine can be tested on the test bed in accordance with ISO 8178-2, the field test
document. This can only occur with the agreement of the parties involved. It should be recognized that data
obtained under these circumstances may not agree completely with previous or future data obtained under the
auspices of this part of ISO 8178. Therefore, it is recommended that this option be exercised only with
engines built in very limited quantities such as very large marine or generating set engines.
For engines used in machinery covered by additional requirements (e.g. occupational health and safety
regulations, regulations for powerplants), additional test conditions and special evaluation methods may apply.
Where it is not possible to use a test bed or where information is required on the actual emissions produced
by an in-service engine, the site test procedures and calculation methods specified in ISO 8178-2 are
appropriate.
文件格式：PDF
文件大小：1.96MB
文件页数：132
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：