ISO 14469-3-2006 道路车辆.压缩天然气(CNG)填充连接器.第3部分_25 MPa (250 bar)连接器.pdf

标准号：ISO 14469-3-2006
实施状态：现行
中文名称：道路车辆.压缩天然气(CNG)填充连接器.第3部分:25 MPa (250 bar)连接器
英文名称：Road vehicles - Compressed natural gas (CNG) refuelling connector - Part 3: 25 MPa (250 bar) connector
发布日期：2006-07
被替代标准：ISO 14469-2017
代替标准：ISO/DIS 14469-3-2005
采用标准：BS ISO 14469-3-2006,IDT
起草单位：ISO/TC 22
标准简介：1.1     This part of ISO 14469 applies to compressed natural gas (CNG) vehicle nozzles and receptacles hereinafter referred to as devices, constructed entirely of new, unused parts and materials. CNG fuelling connection nozzles consist of the following components, as applicable:
a)    receptacle and protective cap (mounted on vehicle) (see Clause 7);
b)    nozzle (see Clause 5).
1.2     This part of ISO 14469 applies to devices which have a service pressure of 250 bar, hereinafter referred to as B250 [see 9 a) 3)].
This part of ISO 14469 refers only to a service pressure of 250 bar.
1.3     This part of ISO 14469 applies to devices with standardized mating components (see 5.8 and 7.7).
1.4     This part of ISO 14469 applies to connectors which:
1)    prevent natural gas vehicles from being fuelled by dispenser stations with service pressures higher than that of the vehicle;
2)    allow natural gas vehicles to be fuelled by dispenser stations with service pressures equal to or lower than the vehicle fuel system service pressure.
1.5     This part of ISO 14469 is applicable to compressed natural gas in accordance with ISO 15403.
1.6     All references to pressures (bar) throughout this part of ISO 14469 are to be considered gauge pressures unless otherwise specified.
文件格式：PDF
文件大小：344.60KB
文件页数：32
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：