ISO 17268-2006 压缩氢路面车辆加油连接设备.pdf

标准号：ISO 17268-2006
实施状态：作废
中文名称：压缩氢路面车辆加油连接设备
英文名称：Compressed hydrogen surface vehicle refuelling connection devices
发布日期：2006-04
被替代标准：ISO 17268-2012
代替标准：ISO/FDIS 17268-2006
采用标准：BS ISO 17268-2007,IDT
起草单位：ISO/TC 197
标准简介：1.1     This International Standard applies to design, safety and operation verification of Compressed Hydrogen Surface Vehicle (CHSV) refuelling connection devices hereinafter referred to as nozzle and receptacle. CHSV Refuelling nozzles and receptacles consist of the following components, as applicable.
—      Receptacle and protective cap (mounted on vehicle);
—      Nozzle.
1.2     This International Standard applies to devices which have working pressures of 25 MPa and 35 MPa, hereinafter referred to in this International Standard as the following:
—   H25-25MPaat15'C
—   H35-35MPaat15'C
1.3     This International Standard applies to nozzles and receptacles which (1) prevent hydrogen fuelled vehicles from being refuelled by dispenser stations with working pressures higher than the vehicle; (2) allow hydrogen vehicles to be refuelled by dispenser stations with working pressures equal to or lower than the vehicle fuel system working pressure; (3) prevent hydrogen fuelled vehicles from being refuelled by other compressed gases dispensing stations; and (4) prevent other gaseous fuelled vehicles from being refuelled by hydrogen dispensing stations.
1.4     All dimensions used in this document are in metric units [International System of Units (SI)].
1.5     For the purposes of this document, compressed hydrogen gas meeting the requirements of ISO 14687 is to be used.
1.6     All references to pressures (MPa) throughout this document are considered gauge pressures unless otherwise specified.
All test procedures listed in this document are design verification test procedures unless otherwise noted.
All products are to pass all tests to be considered to have met this design standard.
文件格式：PDF
文件大小：3.75MB
文件页数：24
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：