ISO 5163-2005 石油产品.发动机和航空燃料爆震特性的测定.马达法.pdf

标准号：ISO 5163-2005
实施状态：作废
中文名称：石油产品.发动机和航空燃料爆震特性的测定.马达法
英文名称：Petroleum products - Determination of knock characteristics of motor and aviation fuels - Motor method
发布日期：2005-06
被替代标准：ISO 5163-2014
代替标准：ISO 5163-1990;ISO/FDIS 5163-2005;ISO 5163 FDAM 1-2005
采用标准：DIN EN ISO 5163-2006,IDT;BS EN ISO 5163-2005,IDT;EN ISO 5163-2005,IDT;prEN ISO 5163-2005,IDT;NF M07-026-2005,IDT;SN EN ISO 5163-2005,IDT;OENORM EN ISO 5163-2006,IDTN-EN ISO 5163-2006,IDTN-EN ISO 5163-2007,IDT;UNE-EN ISO 5163-2006,IDT
起草单位：ISO/TC 28
标准简介：This International Standard establishes the rating of liquid spark-ignition engine fuel in terms of an arbitrary scale of octane numbers using a standard single-cylinder, four-stroke cycle, variable-compression ratio, carburetted, CFR engine operated at constant speed. Motor octane number (MON) provides a measure of the knock characteristics of motor fuels in automotive engines under severe conditions of operation. The motor octane number provides a measure of the knock characteristics of aviation fuels in aviation piston engines, by using an equation to correlate to aviation-method octane number or performance number (lean-mixture aviation rating).
This International Standard is applicable for the entire scale range from 0 MON to 120 MON, but the working range is 40 MON to 120 MON. Typical motor fuel testing is in the range of 80 MON to 90 MON. Typical aviation fuel testing is in the range of 98 MON to 102 MON.
This International Standard can be used for oxygenate-containing fuels containing up to 4,0 % (m/m) oxygen.
Certain gases and fumes, such as halogenated refrigerants used in air-conditioning equipment that can be present in the area where the CFR engine is located, may have a measurable effect on the MON rating. Electrical power transient voltage or frequency surges or distortion can affect MON ratings.
NOTE 1   This International Standard specifies operating conditions in SI units but engine measurements are specified in inch-pound units because these are the units used in the manufacture of the equipment, and thus some references in this International Standard include these units in parenthesis.
NOTE 2   For the purposes of this International Standard, the expressions "% (m/m)" and "% (V/V)" are used to represent the mass and volume fractions of a material, respectively.
文件格式：PDF
文件大小：262.10KB
文件页数：26
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：