麦田学社 下载中心 ISO 5164-2005 石油产品.发动机燃料爆震特性的测定.研究法.pdf

版块导航

热门下载

麦田学社 © my678.cn

ISO 5164-2005 石油产品.发动机燃料爆震特性的测定.研究法.pdf

 

ISO 5164-2005 石油产品.发动机燃料爆震特性的测定.研究法:
标准号:ISO 5164-2005
实施状态:作废
中文名称:石油产品.发动机燃料爆震特性的测定.研究法
英文名称:Petroleum products - Determination of knock characteristics of motor fuels - Research method
发布日期:2005-06
被替代标准:ISO 5164-2014
代替标准:ISO 5164-1990;ISO/FDIS 5164-2005;ISO 5164 FDAM 1-2005
采用标准:DIN EN ISO 5164-2006,IDT;BS EN ISO 5164-2005,IDT;EN ISO 5164-2005,IDT;prEN ISO 5164-2005,IDT;NF M07-027-2005,IDT;SN EN ISO 5164-2005,IDT;OENORM EN ISO 5164-2006,IDTN-EN ISO 5164-2006,IDTN-EN ISO 5164-2007,IDT;UNE-EN ISO 5164-2006,IDT
起草单位:ISO/TC 28
标准简介:This International Standard establishes the rating of liquid spark-ignition engine fuel in terms of an arbitrary scale of octane numbers using a standard single-cylinder, four-stroke cycle, variable compression ratio, carburetted, CFR engine operated at constant speed. Research octane number (RON) provides a measure of the knock characteristics of motor fuels in automotive engines under mild conditions of operation.
This International Standard is applicable for the entire scale range from 0 RON to 120 RON, but the working range is 40 RON to 120 RON. Typical motor fuel testing is in the range of 88 RON to 101 RON.
This International Standard can be used for oxygenate-containing fuels containing up to 4,0 % (mlm) oxygen.
Certain gases and fumes, such as halogenated refrigerants used in air-conditioning equipment, that can be present in the area where the CFR engine is located, may have a measurable effect on the RON rating. Electrical power transient voltage or frequency surges or distortion can affect RON ratings.
NOTE 1   This International Standard specifies operating conditions in SI units but engine measurements are specified in inch-pound units because these are the units used in the manufacture of the equipment, and thus some references in this International Standard include these units in parenthesis.
NOTE 2   For the purposes of this International Standard, the expressions "% (m/m)" and "% (V/V)" are used to represent the mass and volume fractions of a material, respectively.
文件格式:PDF
文件大小:247.70KB
文件页数:26
(以上信息更新时间为:2019-11-22)



文档语言及版本参照下方封面截图:
ISO 5164-2005 石油产品.发动机燃料爆震特性的测定.研究法
点击下方链接查看更多内容。