ISO_TS 15530-3-2004 产品几何量的技术规范(GPS).坐标测量仪(CMM)_测量不确定度的测定技术.第3部分_校准工件或标准件的使用.pdf

标准号：ISO/TS 15530-3-2004
实施状态：作废
中文名称：产品几何量的技术规范(GPS).坐标测量仪(CMM):测量不确定度的测定技术.第3部分:校准工件或标准件的使用
英文名称：Geometrical Product Specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or standards
发布日期：2004-03
被替代标准：ISO 15530-3-2011
采用标准：DIN ISO/TS 15530-3-2005,IDT;DIN ISO/TS 15530-3-2008,IDT;BS DD CEN ISO/TS 15530-3-2009,IDT;GB/T 24635.3-2009,IDT;prEN 15395-3-2005,IDT;CEN ISO/TS 15530-3-2007,IDT;prCEN ISO/TS 15530-3-2007,IDT;OENORM CEN ISO/TS 15530-3-2008,IDT;OENORM CEN ISO/TS 15530-3-2008,IDT;OENORM EN 15395-3-2006,IDT
起草单位：ISO/TC 213
标准简介：This part of ISO 15530 specifies the evaluation of measurement uncertainty for results of measurements
obtained by a CMM and by using calibrated workpieces. It provides an experimental technique for simplifying
the uncertainty evaluation of CMM measurements, whose approach (substitution measurements) leads to
measurements being carried out in the same way as actual measurements, but with calibrated workpieces of
similar dimension and geometry instead of the unknown workpieces to be measured.
Non-substitution measurements on CMMs are also covered, as are the requirements of the uncertainty
evaluation procedure, the measurement equipment needed, and the reverification and the interim check of the
measurement uncertainty.
NOTE The evaluation of measurement uncertainty is always related to a specific measuring task.
文件格式：PDF
文件大小：309.56KB
文件页数：24
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：