ISO 9692-1-2003 焊接和相关工艺.关于接缝准备的建议.第1部分_钢的手动金属电弧焊接、气体保护金属电弧焊、气焊、TIG焊接和束焊.pdf

标准号：ISO 9692-1-2003
实施状态：作废
中文名称：焊接和相关工艺.关于接缝准备的建议.第1部分:钢的手动金属电弧焊接、气体保护金属电弧焊、气焊、TIG焊接和束焊
英文名称：Welding and allied processes - Recommendations for joint preparation - Part 1: Manual metal-arc welding, gas-shielded metal-arc welding, gas welding, TIG welding and beam welding of steels
发布日期：2003-12
被替代标准：ISO 9692-1-2013
代替标准：ISO 9692-1-1992;ISO/FDIS 9692-1-2003
采用标准：DIN EN ISO 9692-1-2004,IDT;DIN EN ISO 9692-1-2000,IDT;BS EN ISO 9692-1-2003,IDT;GB/T 985.1-2008,MOD;EN ISO 9692-1-2003,IDT;NF A87-013-1-2004,IDT;SN EN ISO 9692-1-2004,IDT;OENORM EN ISO 9692-1-2004,IDTN-EN ISO 9692-1-2005,IDTN-EN ISO 9692-1-2008,IDT;UNE-EN ISO 9692-1-2004,IDT
起草单位：ISO/TC 44
标准简介：This part of ISO 9692 specifies types of joint preparation for metal-arc welding with covered electrode, gas-shielded metal-arc welding, gas welding, TIG welding and beam welding of steel (see Clauses 3 and 4).
It applies to joint preparation for full penetration butt welds and for fillet welds. For partial penetration butt welds, types of joint preparation and dimensions differing from those specified in this part of ISO 9692 may be stipulated.
The root gaps referred to in this part of ISO 9692 are those gaps presented after tack welding, if used.
Consideration should be given to altering the joint preparation details (where appropriate) to facilitate temporary backing, "one-sided welding", etc.
文件格式：PDF
文件大小：500.04KB
文件页数：22
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：