ISO 15874-3-2003 冷热水装置用塑料管道系统.聚丙烯(PP).第3部分_配件.pdf

标准号：ISO 15874-3-2003
实施状态：作废
中文名称：冷热水装置用塑料管道系统.聚丙烯(PP).第3部分:配件
英文名称：Plastics piping systems for hot and cold water installations - Polypropylene (PP) - Part 3: Fittings
发布日期：2003-12
被替代标准：ISO 15874-3-2013
代替标准：ISO/FDIS 15874-3-2002
采用标准：DIN EN 12202-3-1996,IDT;DIN EN ISO 15874-3-2004,IDT;BS EN ISO 15874-3-2004,IDT;GB/T 18742.3-2002,NEQ;EN ISO 15874-3-2003,IDT;NF T54-938-3-2004,IDT;SN EN ISO 15874-3-2004,IDT;OENORM EN ISO 15874-3-2004,IDT;OENORM EN ISO 15874-3/A1-2006,IDT;OENORM EN ISO 15874-3/A1-2009,IDTN-EN ISO 15874-3-2005,IDT;UNE-EN ISO 15874-3-2004,IDT
起草单位：ISO/TC 138
标准简介：This Part of EN ISO 15874 specifies the characteristics of fittings for polypropylene (PP) piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water, whether or not intended for human consumption (domestic systems) and for heating systems under design pressures and temperatures according to the class of application (see Table 1 of EN ISO 15874-1:2003).
This standard covers a range of service conditions (application classes) and design pressure classes. For values of TD, Tmax and Tmal in excess of those in Table 1 of Part 1, this standard does not apply.
NOTE        It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.
It also specifies the parameters for the test methods referred to in this standard.
In conjunction with the other parts of EN ISO 15874 (see Foreword) it is applicable to fittings made from PP and to fittings made from other materials which are intended to be fitted to pipes conforming to EN ISO 15874-2 for hot and cold water installations and whereby the joints conform to the requirements of EN ISO 15874-5.
It is also applicable to fittings made from alternative materials which when fitted to pipes conforming to Part 2, conform to the requirements of Part 5 of EN ISO 15874.
This standard is applicable to fittings of the following types:
—  socket fusion fittings
—  electrofusion fittings
—  mechanical fittings
—  fittings with incorporated inserts
文件格式：PDF
文件大小：220.39KB
文件页数：22
（以上信息更新时间为：2019-11-22）



文档语言及版本参照下方封面截图：