ISO 4628-7-2003 色漆和清漆.漆膜降解的评定.缺陷量值、大小以及外观均匀变化程度的规定.第7部分_用丝绒法评定粉化等级.pdf

标准号：ISO 4628-7-2003
实施状态：作废
中文名称：色漆和清漆.漆膜降解的评定.缺陷量值、大小以及外观均匀变化程度的规定.第7部分:用丝绒法评定粉化等级
英文名称：Paints and varnishes - Evaluation of degradation of coatings; Designation of quantity and size of defects, and of intensity of uniform changes in appearance - Part 7: Assessment of degree of chalking by velvet method
发布日期：2003-09
被替代标准：ISO 4628-7-2016
代替标准：ISO/FDIS 4628-7-2003
采用标准：DIN EN ISO 4628-7-2004,IDT;BS EN ISO 4628-7-2003,IDT;EN ISO 4628-7-2003,IDT;NF T30-071-7-2004,IDT;SN EN ISO 4628-7-2004,IDT;OENORM EN ISO 4628-7-2004,IDTN-EN ISO 4628-7-2005,IDT;UNE-EN ISO 4628-7-2004,IDT
起草单位：ISO/TC 35
标准简介：This part of ISO 4628 describes a method suitable, in particular, for rating the degree of chalking on white or coloured exterior coatings and coating systems on rough surfaces (i.e. those having a roughness greater than segment 4 of reference comparator G as described in ISO 8503-1).
The test method specified may also be used for the assessment of the degree of chalking of coatings and coating systems on smooth surfaces, but the method specified in ISO 4628-6 is preferable for this purpose.
The test method is applicable to coatings and coating systems on mineral substrates, e.g. fibre cement, brick, concrete and renderings, independent of the structure of the surface. The method can be used quite effectively by experienced operators and is recommended for laboratory use as well as for on-site evaluation.
NOTE 1    When a reference to this test method is included in specifications, the test conditions (i.e. weathering method and substrate) should be agreed between the interested parties.
NOTE 2    The method described in this part of ISO 4628 is a relative ranking method and is therefore not suitable for use in agreements between parties. See, however, the Note to Table 1.
ISO 4628-1 defines the system used for designating the quantity and size of defects and the intensity of changes in appearance of coatings and outlines the general principles of the system. This system is intended to be used, in particular, for defects caused by ageing and weathering, and for uniform changes such as colour changes, for example yellowing.
文件格式：PDF
文件大小：137.61KB
文件页数：8
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：