ISO 13849-2-2003 机械安全.控制系统的安全相关部件.第2部分_验证.pdf

标准号：ISO 13849-2-2003
实施状态：作废
中文名称：机械安全.控制系统的安全相关部件.第2部分:验证
英文名称：Safety of machinery - Safety-related parts of control systems - Part 2: Validation
发布日期：2003-08
被替代标准：ISO 13849-2-2012
代替标准：ISO/FDIS 13849-2-2002
采用标准：DIN EN ISO 13849-2-2003,IDT;DIN EN ISO 13849-2-2008,IDT;BS EN ISO 13849-2-2003,IDT;BS EN ISO 13849-2-2008,IDT;GB/T 16855.2-2007,IDT;EN ISO 13849-2-2003,IDT;EN ISO 13849-2-2008,IDT;prEN ISO 13849-2-2008,IDT;NF E09-025-2-2004,IDT;NF E09-025-2-2008,IDT;E09-025-2/A1PR,IDT;SN EN ISO 13849-2-2003,IDT;SN EN ISO 13849-2-2008,IDT;OENORM EN ISO 13849-2-2003,IDT;OENORM EN ISO 13849-2-2009,IDT;OENORM EN ISO 13849-2-2008,IDTN-EN ISO 13849-2-2005,IDTN-EN ISO 13849-2-2008,IDT;UNE-EN ISO 13849-2-2004,IDT;UNE-EN ISO 13849-2-2008,IDT
起草单位：ISO/TC 199
标准简介：This European Standard specifies the procedures and conditions to be followed for the validation by analysis and testing of:
—  the safety functions provided, and
—  the category achieved
of the safety-related parts of the control system in compliance with EN 954-1 (ISO 13849-1), using the design rationale provided by the designer.
This European Standard does not give complete validation requirements for programmable electronic systems and therefore can require the use of other standards.
NOTE    CEN/TC 114/WG 6 proposes to deal in more detail with the validation of programmable electronic systems in the elaboration of the revision to EN 954-1 (ISO 13849-1). An application standard for machinery (draft IEC 62061), based on IEC 61508, is under preparation. Requirements for programmable electronic systems, including embedded software, are given in IEC 61508.
文件格式：PDF
文件大小：784.26KB
文件页数：58
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：