ISO 8503-5-2003 涂装油漆和有关产品前钢材预处理.喷射清理钢材的表面粗糙度特性.第5部分_表面轮廓测定的复制带法.pdf

标准号：ISO 8503-5-2003
实施状态：作废
中文名称：涂装油漆和有关产品前钢材预处理.喷射清理钢材的表面粗糙度特性.第5部分:表面轮廓测定的复制带法
英文名称：Preparation of steel substrates before application of paints and related products - Surface roughness characteristics of blast-cleaned steel substrates - Part 5: Replica tape method for the determination of the surface profile
发布日期：2003-07
被替代标准：ISO 8503-5-2017
代替标准：ISO/DIS 8503-5-2001
采用标准：DIN EN ISO 8503-5-2005,IDT;DIN EN ISO 8503-5-2004,IDT;BS EN ISO 8503-5-2003,IDT;GB/T 13288.5-2009,IDT;EN ISO 8503-5-2004,IDT;prEN ISO 8503-5-2004,IDT;NF T35-503-5-2005,IDT;T35-503-5PR,IDT;SN EN ISO 8503-5-2005,IDT;OENORM EN ISO 8503-5-2005,IDT;OENORM EN ISO 8503-5-2004,IDTN-EN ISO 8503-5-2006,IDT;UNE-EN ISO 8503-5-2006,IDT
起草单位：ISO/TC 35
标准简介：This part of ISO 8503 describes a field method for measuring the surface profile produced by any of the abrasive blast-cleaning procedures given in ISO 8504-2. The method uses replica tape and a suitable gauge for measuring, on site, the roughness of a surface before the application of paint or another protective coating.
The method is applicable within the range of profiles cited for a given grade (or thickness) of replica tape. The commercial grades currently available permit measurement of average peak-to-valley profiles of 20 μm to 115 μm. The method is valid for surfaces that have been cleaned with either metallic or non-metallic abrasives.
文件格式：PDF
文件大小：446.39KB
文件页数：14
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：