ISO_TS 17263-2003 自动车辆和设备识别.货物联运.系统参数.pdf

标准号：ISO/TS 17263-2003
实施状态：作废
中文名称：自动车辆和设备识别.货物联运.系统参数
英文名称：Automatic vehicle and equipment identification - Intermodal goods transport - System parameters
发布日期：2003-06-01
被替代标准：ISO 17263-2012
采用标准：DIN ISO/TS 17263-2005,IDT;BS DD CEN ISO/TS 17263-2003,IDT;CEN ISO/TS 17263-2003,IDT
起草单位：ISO/TC 204
标准简介：1  General
This Technical Specification establishes an AEI-System based on radio frequency technologies. This system is intended for general application in RTTT/TICS. It allows the transfer of the identification codes and further information about equipment and vehicles used in intermodal transport into such RTTT/TICS and information systems related to Intermodal Transport processes. Within the intermodal context of the RTTT/TICS Sector, AEI systems have the specific objective of achieving an unambiguous identification of an ITU or related equipment or vehicle or item used in intermodal transport, and to make that identification automatically. Vehicles will be considered and handled under Intermodal aspects as Intermodal Equipment". Therefore a differentiation between AEI and AVI systems under the purpose of this standard is not required.
This Technical Specification is specifically aimed at DSRC-type air interfaces. The requirement and test methods may not apply for Intermodal AEI systems using long range communications such as Cellular Networks or Satellite, or vicinity communication such as inductively coupled antennas. The interoperability across the air interface (reference point Delta) is outside the scope of this Technical Specification. Please see CEN ISO/TS 17264 Automatic Vehicle and Equipment Identification (AVI/AEI) -AVI/AEI Interfaces (under preparation).
2  Aim
The aim of this standard is to define, describe and specify the System Parameters related to an intermodal AEI system to provide an enabling Standard, which, whilst allowing the system specifier to determine the performance levels and operating conditions, provides a framework for interoperability. Therefore this Technical Specification specifies:
a)  parameters and requirements of the identification system itself
b)  performance criteria necessary to ensure consistent and reliable operation of AEI systems within international transport processing
c)  requirements of the performance and the position of the electronic devices (tag) when installed on intermodal equipment
d)  requirements for the installation of readers, and performance data related to these components.
NOTE: These parameters of an AEI system shall be identical, compatible or interoperable world-wide in respect of systems complying to this Pre-Standard. Yet it is recognised that, at the implementation level, there may be requirements for regional or operational differences in the performance levels achieved against these parameters.
3  Pre-requisite
Any system to read identity and related data has to be based on a standardised system to allocate an unambiguous identity to each item, vehicle, load unit or equipment as defined in CEN ISO/TS 17262 Automatic vehicle and equipment identification - Intermodal goods transport - Numbering and data structures.
文件格式：PDF
文件大小：337.32KB
文件页数：18
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：