ISO 1641-3-2003 端铣刀和槽铣刀.第3部分_7_24锥柄铣刀.pdf

标准号：ISO 1641-3-2003
实施状态：作废
中文名称：端铣刀和槽铣刀.第3部分:7/24锥柄铣刀
英文名称：End mills and slot drills - Part 3: Milling cutters with 7/24 taper shanks
发布日期：2003-06
被替代标准：ISO 1641-3-2011
代替标准：ISO 1641-3-1978;ISO/FDIS 1641-3-2002
采用标准：BS ISO 1641-3-2003,IDT;NF E66-215-3-2003,IDT;GOST R 53002-2008,IDT;GOST R 53003-2008,IDT
起草单位：ISO/TC 29
标准简介：This part of ISO 1641 specifies the general dimensions of the following milling cutters with 7/24 taper shanks:
—  end mills, flat-ended or ball-nosed — standard series and long series (manual changers);
—  slot drills — short series and standard series (manual changers);
—  end mills, flat-ended — standard series and long series (automatic changers).
Characteristics of 7/24 taper are in accordance with ISO 297 for manual changers and ISO 7388-1 for automatic changers.
NOTE  These same milling cutters with cylindrical shanks are dealt with in ISO 1641-1, and those with Morse taper shank having a tapped hole in ISO 1641-2.
文件格式：PDF
文件大小：151.52KB
文件页数：10
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：