ISO 10366-1-2002 塑料.甲基丙烯酸甲酯_丁二烯_苯乙烯共聚物(ABS)的模塑和挤塑材料.命名系统和规范基础.pdf

标准号：ISO 10366-1-2002
实施状态：作废
中文名称：塑料.甲基丙烯酸甲酯/丁二烯/苯乙烯共聚物(ABS)的模塑和挤塑材料.命名系统和规范基础
英文名称：Plastics - Methyl methacrylate-acrylonitrile-butadiene-styrene (MABS) moulding and extrusion materials - Part 1: Designation system and basis for specifications
发布日期：2002-10
被替代标准：ISO 19066-1-2014
代替标准：ISO 10366-1-1993;ISO/FDIS 10366-1-2002
采用标准：DIN EN ISO 10366-1-2003,IDT;BS EN ISO 10366-1-2002,IDT;EN ISO 10366-1-2002,IDT;NF T53-038-1-2004,IDT;JIS K 6938-1-2006,IDT;SN EN ISO 10366-1-2002,IDT;OENORM EN ISO 10366-1-2003,IDTN-EN ISO 10366-1-2004,IDT;UNE-EN ISO 10366-1-2003,IDT
起草单位：ISO/TC 61
标准简介：1    This part of ISO 10366 establishes a system of designation for methyl methacrylate-acrylonitrile-butadiene-styrene (MABS) moulding and extrusion materials, which may be used as the basis for specifications.
2    The types of MABS plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties
a)   Vicat softening temperature
b)   melt volume-flow rate
c)   Charpy notched impact strength
d)   tensile modulus
and on information about composition, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials.
3    I This part of ISO 10366 is applicable to all methyl methacrylate-acrylonitrile-butadiene-styrene materials consisting of a continuous phase based mainly on copolymers of styrene (and/or an alkyl-substituted styrene), acrylonitrile and methyl methacrylate and a dispersed elastomeric phase based on butadiene.
It applies to MABS materials ready for normal use in the form of powder, granules or pellets, unmodified or modified by colorants, additives, fillers, etc.
4    It is not intended to imply that materials having the same designation give necessarily the same performance. This part of ISO 10366 does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application and/or method of processing.
If such additional properties are required, they shall be determined in accordance with the test methods specified in part 2 of this International Standard, if suitable.
5    In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements may be given in data block 5 (see 3.1).
文件格式：PDF
文件大小：385.14KB
文件页数：14
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：