IEC 60034-15-1995 旋转电机 第15部分_带定子成型线圈的交流旋转电机的冲击电压耐受水平.pdf

标准号：IEC 60034-15-1995
实施状态：作废
中文名称：旋转电机 第15部分:带定子成型线圈的交流旋转电机的冲击电压耐受水平
英文名称：Rotating electrical machines - Part 15: Impulse voltage withstand levels of rotating a.c. machines with form-wound stator coils
发布日期：1995-01
被替代标准：IEC 60034-15-2009
代替标准：IEC/DIS 2(CO)577-1992;IEC 60034-15-1990
采用标准：DIN EN 60034-15-1996,IDT;BS EN 60034-15-1996,IDT;EN 60034-15-1996,IDT;prEN 60034-15-1995,IDT;NF C51-350-1997,IDT;C51-350PR,IDT;OEVE EN 60034-15-1996,IDT;UNE-EN 60034-15-1997,IDT
起草单位：IEC/TC 2
标准简介：This technical specification deals with the steady-state operation of cage induction motors within the scope of IEC 60034-12, when fed from converters. It covers the operation over the whole speed setting range, but does not deal with starting or transient phenomena.
Only indirect type converters are dealt with. This type comprises converters with impressed direct current in the intermediate circuit (current source converters) and converters with impressed d.c. voltage (voltage source converters), either of the block type or the pulse controlled type, without restriction on pulse number, pulse width or pulse frequency. For the purpose of this technical specification, a converter may include any type of electronic switching device, for example transistors (bipolar or MOSfet), IGBTs, thyristors, GTO-thyristors, etc. with analog or digital control electronics.
文件格式：PDF
文件大小：883.87KB
文件页数：22
（以上信息更新时间为：2019-11-25）



文档语言及版本参照下方封面截图：