ISO 5951-2001 改进成形性的热轧高屈服点薄钢板.pdf

标准号：ISO 5951-2001
实施状态：作废
中文名称：改进成形性的热轧高屈服点薄钢板
英文名称：Hot-rolled steel sheet of higher yield strength with improved formability
发布日期：2001-10
被替代标准：ISO 5951-2008
代替标准：ISO 5951-1993;ISO/DIS 5951-2000
采用标准：DIN EN 10051-1997,MOD;DIN EN 10149-1-1995,MOD;DIN EN 10149-2-1995,MOD;DIN EN 10149-3-1995,MOD
起草单位：ISO/TC 17
标准简介：1  This International Standard applies to continuously hot-rolled steel sheet of higher yield strength with improved formability in the grades listed in Table 1. The steel is killed, made according to a fine grain practice and has a suitable chemical composition, which may include microalloying elements, to provide improved formability. The product is intended for applications where parts are to be fabricated requiring better formability than is provided by normal high yield strength steel sheet. It is generally used in the delivered condition.
Because of the combination of higher strength and improved formability, it is possible to obtain savings in mass along with better weldability.
2  This product is commonly produced in the range of thicknesses of 1,6 mm and over and widths of 600 mm and over, in coils and cut lengths.
3  Hot-rolled sheet less than 600 mm wide may be slit from wide sheet and will be considered as sheet.
NOTE    Hot-rolled sheet up to but not including 3 mm in thickness is commonly known as sheet. Hot-rolled sheet 3 mm and over in thickness is commonly known as either '"sheet" or "plate".
4  This International Standard does not cover steel intended for boilers or pressure vessels, or steels designated as commercial quality or drawing qualities (covered in ISO 3573), or steels designated as weathering steels, having increased atmospheric corrosion resistance, or lower yield strength steels having less formability properties (covered in ISO 4995 and ISO 4996) compared with those included in this International Standard.
文件格式：PDF
文件大小：188.21KB
文件页数：18
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：