ISO 10300-2-2001 斜齿轮承载能力的计算 第2部分：齿轮表面强度（点蚀）的计算.pdf

标准号：ISO 10300-2-2001
实施状态：作废
中文名称：斜齿轮承载能力的计算  第2部分：齿轮表面强度（点蚀）的计算
英文名称：Calculation of load capacity of bevel gears - Part 2: Calculation of surface durability (pitting)
发布日期：2001-08
被替代标准：ISO 10300-2-2014
代替标准：ISO/FDIS 10300-2-2000
采用标准：DIN 3991-2-1988,MOD;94/710466 DC-1994,IDT;BS ISO 10300-2-2001,IDT;GB/T 10062.2-2003,IDT;OENORM ISO 10300-2-2006,IDT;OENORM ISO 10300-2-2005,IDT
起草单位：ISO/TC 60
标准简介：This part of ISO 10300 specifies the basic formulae for use in the determination of the surface load capacity of straight and helical (skew), zerol- and spiral-bevel gears, and includes all the influences on surface durability for which quantitative assessments can be made. This part of ISO 10300 is applicable to oil-lubricated transmissions, as long as sufficient lubricant is present in the mesh at all times.
The formulae in ISO 10300 are valid for bevel gears with teeth where the transverse contact ratio is εvα < 2. The results are valid within the range of the applied factors as indicated in ISO 10300-1, and in ISO 6336-2. However, the formulae in this part of ISO 10300 are not directly applicable in the assessment of certain types of gear-tooth surface damage, such as plastic yielding, scratching, scuffing or any other type not specified.
CAUTION — The user is cautioned that when the methods are used for large spiral and pressure angles, and for large face width b > 10 mmn, the calculated results of ISO 10300 should be confirmed by experience.
文件格式：PDF
文件大小：611.99KB
文件页数：23
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：