ISO 10350-2-2001 塑料 可比单点数据的采集和表示 第2部分：长纤维增强塑料.pdf

标准号：ISO 10350-2-2001
实施状态：作废
中文名称：塑料  可比单点数据的采集和表示  第2部分：长纤维增强塑料
英文名称：Plastics - Acquisition and presentation of comparable single-point data - Part 2: Long-fibre-reinforced plastics
发布日期：2001-06
被替代标准：ISO 10350-2-2011
代替标准：ISO 10350-1993;ISO/FDIS 10350-2-2001
采用标准：DIN EN ISO 10350-2-2001,IDT;BS EN ISO 10350-2-2001,IDT;GB/T 19467.2-2004,IDT;EN ISO 10350-2-2001,IDT;NF T50-062-2-2002,IDT;JIS K 7140-2-2007,IDT;SN EN ISO 10350-2-2001,IDT;OENORM EN ISO 10350-2-2001,IDTN-EN ISO 10350-2-2003,IDT;UNE-EN ISO 10350-2-2002,IDT
起草单位：ISO/TC 61
标准简介：ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions or along different directions in the material. The properties included are those presented conventionally in manufacturers' data sheets. This part of ISO 10350 applies to reinforced thermoplastic and thermosetting materials where the reinforcement fibres are either discontinuous with a fibre length prior to processing greater than 7,5 mm or continuous (e.g. fabric, continuous-strand mat or unidirectional). Part 1 of this International Standard deals specifically with unreinforced and filled plastics, including those using fibres less than 7,5 mm in length.
文件格式：PDF
文件大小：100.94KB
文件页数：14
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：