ISO 6145-5-2001 气体分析 用动态容量法制备标定用混合气体 第5部分：毛细管校准仪器.pdf

标准号：ISO 6145-5-2001
实施状态：作废
中文名称：气体分析  用动态容量法制备标定用混合气体 第5部分：毛细管校准仪器
英文名称：Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 5: Capillary calibration devices
发布日期：2001-04
被替代标准：ISO 6145-5-2009
代替标准：ISO/FDIS 6145-5-2000
采用标准：BS ISO 6145-5-2001,IDT;UNE-ISO 6145-5-2006,IDT;GOST R ISO 16017-1-2007,MOD
起草单位：ISO/TC 158
标准简介：This part of ISO 6145 specifies a technique for the continuous production of calibration gas mixtures from pure gases or gas mixtures using capillary devices in single or multiple combinations (gas dividers).
Single capillary systems can be used to provide gas mixtures where the minor component is in the range of volume fractions from 10<up-8> to 0,5.
The relative repeatability of this technique is approximately 2 %. This application is used in industrial gas mixing panels for the production of specific gas atmospheres.
Gas dividers can be used to divide gas mixtures prepared from gases or gas mixtures into controlled proportions by volume. These devices are capable of dilutions in the range of volume fractions from 0,1 to 0,9 of the primary gas with a relative repeatability of better than 0,5 %.
Traceability of the gas mixtures produced by a gas divider can be achieved by comparison of a mixture at the higher and lower end of the range with gas mixtures related to national or international gas standards. An example is given in annex A.
文件格式：PDF
文件大小：129.59KB
文件页数：18
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：