ISO 3747-2000 声学 声压法测定噪声源声功率级 现场比较法.pdf

标准号：ISO 3747-2000
实施状态：作废
中文名称：声学 声压法测定噪声源声功率级 现场比较法
英文名称：Acoustics - Determination of sound power levels of noise sources using sound pressure - Comparison method in situ
发布日期：2000-07
被替代标准：ISO 3747-2010
代替标准：ISO 3747-1987;ISO/FDIS 3747-2000
采用标准：DIN EN ISO 3747-2001,IDT;DIN EN ISO 3747-2009,IDT;ANSI/ISO 3747-2000,IDT;BS EN ISO 3747-2000,IDT;BS EN ISO 3747-2010,IDT;GB/T 16538-2008,IDT;EN ISO 3747-2000,IDT;EN ISO 3747-2009,IDT;FprEN ISO 3747-2009,IDT;NF S31-067-2000,IDT;NF S31-067-2009,IDT;SN EN ISO 3747-2000,IDT;SN EN ISO 3747-2010,IDT;OENORM EN ISO 3747-2000,IDT;OENORM EN ISO 3747-2010,IDT;OENORM EN ISO 3747/A1-2009,IDTN-EN ISO 3747-2003,IDTN-EN ISO 3747-2010,IDT;UNE-EN ISO 3747-2001,IDT;UNE-EN ISO 3747-2010,IDT;GOST 27243-2005,IDT
起草单位：ISO/TC 43
标准简介：1  This International Standard specifies a method for determining the sound power levels of sound sources in situ, especially if non-movable. A comparison method is used and all measurements are carried out in octave bands. The measurement uncertainty depends on the test environment. The measurement uncertainty is evaluated by comparing with an indicator describing the spatial sound distribution. The accuracy will either be that of an engineering method or a survey method.
The sound power level of the source under test is calculated from the measured values of the sound pressure levels produced at specified measurement points by the source and by a reference sound source, respectively. The sound power level is calculated using the calibrated values of the reference sound source and the differences between the values obtained with the source under test and those of the reference sound source. All calculations are carried out in octave bands, from which the A-weighted sound power level is determined.
NOTE  For noise sources which can be moved, other relevant standards in the ISO 3740 series may be used.
2  This International Standard is applicable to all kinds of test environments which are to be found outside a laboratory environment, provided that the background noise level is sufficiently low and the sound pressure level at the microphone positions depends mainly on reflections from the room surfaces.
NOTE  ISO 3744 or ISO 9614 may provide alternative methods.
3  This International Standard is primarily applicable to sources which radiate broad-band noise. It may, however, also be used for sources which radiate narrow-band noise or discrete tones, although the measurement uncertainty might then become larger than stated herein.
NOTE  For noise sources emitting stationary noise, ISO 9614 may be used as an alternative.
文件格式：PDF
文件大小：712.58KB
文件页数：26
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：