ISO 15526-2-2000 塑料 聚酮(PK)模塑和挤塑材料 第2部分_试样的制备和性能的测定.pdf

标准号：ISO 15526-2-2000
实施状态：作废
中文名称：塑料 聚酮(PK)模塑和挤塑材料 第2部分:试样的制备和性能的测定
英文名称：Plastics - Polyketone (PK) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties
发布日期：2000-06
代替标准：ISO/FDIS 15526-2-1999
采用标准：DIN EN ISO 15526-2-2004,IDT;DIN EN ISO 15526-2-2004,IDT;BS EN ISO 15526-2-2004,IDT;EN ISO 15526-2-2004,IDT;prEN ISO 15526-2-2003,IDT;NF T53-040-2-2004,IDT;T53-040-2PR,IDT;SN EN ISO 15526-2-2004,IDT;OENORM EN ISO 15526-2-2004,IDT;OENORM EN ISO 15526-2-2004,IDT;UNE-EN ISO 15526-2-2005,IDT
起草单位：ISO/TC 61
标准简介：This part of ISO 15526 specifies the methods of preparation of test specimens and the test methods to be used in determining the properties of polyketone moulding and extrusion materials. Requirements for handling test material and for conditioning both the test material before moulding and the specimens before testing are given here.
Procedures and conditions for the preparation of test specimens and procedures for measuring properties of the materials from which these specimens are made are given. Properties and test methods which are suitable and necessary to characterize polyketone moulding and extrusion materials are listed.
The properties have been selected from the general test methods in, ISO 10350:1993. Other test methods in wide use for or of particular significance to these moulding and extrusion materials are also included in this part of ISO 15526, as are the designatory properties specified in part 1.
In order to obtain reproducible and comparable test results, it is necessary to use the methods of preparation and conditioning, the specimen dimensions and the test procedures specified herein. Values determined will not neces-sarily be identical to those obtained using specimens of different dimensions or prepared using different procedures.
文件格式：PDF
文件大小：87.69KB
文件页数：10
（以上信息更新时间为：2019-11-23）



文档语言及版本参照下方封面截图：