ISO 15526-1-2000 塑料 聚酮(PK)模塑和挤塑材料 第1部分_命名系统和基本规范.pdf

标准号：ISO 15526-1-2000
实施状态：作废
中文名称：塑料 聚酮(PK)模塑和挤塑材料 第1部分:命名系统和基本规范
英文名称：Plastics - Polyketone (PK) moulding and extrusion materials - Part 1: Designation system and basis for specifications
发布日期：2000-06
代替标准：ISO/FDIS 15526-1-1999
采用标准：DIN EN ISO 15526-1-2004,IDT;DIN EN ISO 15526-1-2004,IDT;BS EN ISO 15526-1-2004,IDT;EN ISO 15526-1-2004,IDT;prEN ISO 15526-1-2003,IDT;NF T53-040-1-2004,IDT;T53-040-1PR,IDT;SN EN ISO 15526-1-2004,IDT;OENORM EN ISO 15526-1-2004,IDT;OENORM EN ISO 15526-1-2004,IDT;UNE-EN ISO 15526-1-2005,IDT
起草单位：ISO/TC 61
标准简介：1  This part of ISO 15526 establishes a system of designation for PK thermoplastic material which may be used as the basis for specifications. PK polymer chains are built up from regularly alternating olefinic units and keto groups. The olefinic units may be essentially all ethylene, or they may be, e.g., randomly distributed ethylene and pro-pylene, butene or hexene.
2  The types of polyketone plastics are differentiated from each other by a classification system based on appropriate levels of the designatory properties
a)  melting temperature
b)  melt volume-flow rate
c)  temperature of deflection under load
and on information about basic polymer parameters, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials.
3  This part of ISO 15526 applies to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc.
4  It is not intended to imply that materials having the same designation give necessarily the same performance. This part of ISO 15526 does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application and/or method of processing.
If such additional properties are required, they shall be determined in accordance with the test methods specified in ISO 15526-2, if suitable.
5  In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements may be given in data block 5 (see 3.1).
文件格式：PDF
文件大小：287.14KB
文件页数：14
（以上信息更新时间为：2019-11-23）

标准全文下载：


文档语言及版本参照下方封面截图：