IEC 61347-1-2007 灯控装置.第1部分_一般安全要求.pdf

标准号：IEC 61347-1-2007
实施状态：作废
中文名称：灯控装置.第1部分:一般安全要求
英文名称：Lamp controlgear - Part 1: General and safety requirements
发布日期：2007-01
被替代标准：IEC 61347-1-2015
代替标准：IEC 34C/776/FDIS-2006;IEC 61347-1-2000;IEC 61347-1 AMD 1-2003;IEC 61347-1 Edition 1.1-2003;IEC 61347-1 Interpretation Sheet 01-2006
采用标准：DIN EN 61347-1-2009,MOD;BS EN 61347-1-2008,MOD;GB 19510.1-2009,IDT;EN 61347-1-2008,MOD;prEN 61347-1-2007,MOD;NF C71-247-0-2008,MOD;OEVE/OENORM EN 61347-1-2009,MODN-EN 61347-1-2008,MODN-EN 61347-1-2010,MOD;UNE-EN 61347-1-2009,MOD
起草单位：IEC/SC 34C
标准简介：This part of IEC 61347 specifies general and safety requirements for lamp controlgear for use
on d.c. supplies up to 250 V and/or a.c. supplies up to 1 000 V at 50 Hz or 60 Hz.
This standard also covers lamp controlgear for lamps which are not yet standardized.
Tests dealt with in this standard are type tests. Requirements for testing individual lamp
controlgear during production are not included.
Requirements for semi-luminaires are given in IEC 60598-1 (see definition 1.2.60).
In addition to the requirements given in this Part 1 of IEC 61347, Annex B sets out general
and safety requirements applicable to thermally protected lamp controlgear.
Annex C sets out additional general and safety requirements as they apply to electronic lamp
controlgear with means of protection against overheating.
Additional requirements for built-in ballasts with double or reinforced insulation are given in
Annex I.
文件格式：PDF
文件大小：1.00MB
文件页数：134
（以上信息更新时间为：2019-11-25）

标准全文下载：


文档语言及版本参照下方封面截图：