标准号：IEC 60287-1-1-2006
实施状态：现行
中文名称：电缆.计算额定电流.第1-1部分:额定电流方程(100%负载因数)和损耗计算.总则
英文名称：Electric cables - Calculation of the current rating - Part 1-1: Current rating equations (100 % load factor) and calculation of losses - General
发布日期：2006-12
代替标准：IEC 20/851/FDIS-2006;IEC 60287-1-1-1994;IEC 60287-1-1 AMD 1-1995;IEC 60287-1-1 AMD 2-2001;IEC 60287-1-1 Edition 1.2-2001;IEC 60287-1-1 Edition 1.2 Corrigendum 1-2006
采用标准：BS IEC 60287-1-1-2007,IDT;GOST R IEC 60287-1-1-2009,IDT
起草单位：IEC/TC 20
标准简介：This part of IEC 60287 is applicable to the conditions of steady-state operation of cables at all
alternating voltages, and direct voltages up to 5 kV, buried directly in the ground, in ducts,
troughs or in steel pipes, both with and without partial drying-out of the soil, as well as cables
in air. The term "steady state" is intended to mean a continuous constant current (100 % load
factor) just sufficient to produce asymptotically the maximum conductor temperature, the
surrounding ambient conditions being assumed constant.
This part provides formulae for current ratings and losses.
The formulae given are essentially literal and designedly leave open the selection of certain
important parameters. These may be divided into three groups:
– parameters related to construction of a cable (for example, thermal resistivity of insulating
material) for which representative values have been selected based on published work;
– parameters related to the surrounding conditions, which may vary widely, the selection of
which depends on the country in which the cables are used or are to be used;
– parameters which result from an agreement between manufacturer and user and which
involve a margin for security of service (for example, maximum conductor temperature).
文件格式：PDF
文件大小：558.02KB
文件页数：74
（以上信息更新时间为：2019-11-25）
IEC 60287-1-1-2006 电缆.计算额定电流.第1-1部分_额定电流方程(100%负载因数)和损耗计算.总则.pdf
(558.02 KB)
|
|
