标准号：IEC 62271-202-2006
实施状态：作废
中文名称：高压开关设备和控制设备.第202部分:预制的高压/低压变电站
英文名称：High-voltage switchgear and controlgear - Part 202: High-voltage/low-voltage prefabricated substation
发布日期：2006-06-01
被替代标准：IEC 62271-202-2014
代替标准：IEC 17C/371/FDIS-2006;IEC 61330-1995
采用标准：DIN EN 62271-202-2007,IDT;BS EN 62271-202-2007,IDT;GB 17467-2010,MOD;EN 62271-202-2007,IDT;NF C64-471-202-2007,IDT;OEVE/OENORM EN 62271-202-2007,IDT;PN-EN 62271-202-2007,IDT;PN-EN 62271-202-2010,IDT;UNE-EN 62271-202-2007,IDT
起草单位：IEC/SC 17C
标准简介：This part of IEC 62271 specifies the service conditions, rated characteristics, general
structural requirements and test methods of HV/LV or LV/HV prefabricated substations, which
are cable-connected, to be operated from inside (walk-in type) or outside (non-walk-in type)
for alternating current of rated voltages above 1 kV and up to and including 52 kV on the HV
side, and for one or more transformers for service frequencies up to and including 60 Hz for
outdoor installation in locations with public accessibility.
Prefabricated substations can be situated at ground level or partially or completely below
ground level.
In general, a prefabricated substation comprises the following main components (functions):
– enclosure;
– power transformers;
– HV and LV switchgear and controlgear;
– HV and LV interconnections;
– auxiliary equipment and circuits.
However, relevant provisions of this standard are applicable to designs where not all these
components exist (for example, an installation consisting of power transformer and LV
switchgear).
NOTE Non-prefabricated substations should comply with the applicable requirements of IEC 61936-1.
文件格式：PDF
文件大小：1.20MB
文件页数：148
（以上信息更新时间为：2019-11-25）
IEC 62271-202-2006 高压开关设备和控制设备.第202部分_预制的高压_低压变电站.pdf
(1.2 MB)
|
|
