标准号：ISO/TR 15144-1-2010
实施状态：作废
中文名称：圆柱正齿轮和斜齿轮的微点蚀承载能力计算.第1部分:简介与基本原理
英文名称：Calculation of micropitting load capacity of cylindrical spur and helical gears - Part 1: Introduction and basic principles
发布日期：2010-12-15
实施日期：2010-12-15
被替代标准：ISO/TR 15144-1-2014
采用标准：FD E23-031-1-2011,IDT
起草单位：ISO/TC 60
标准简介：This part of ISO/TR 15144 describes a procedure for the calculation of the micropitting load capacity of cylindrical gears with external teeth. It has been developed on the basis of testing and observation of oil-lubricated gear transmissions with modules between 3 mm and 11 mm and pitch line velocities of 8 m/s to 60 m/s. However, the procedure is applicable to any gear pair where suitable reference data is available, providing the criteria specified below are satisfied.
The formulae specified are applicable for driving as well as for driven cylindrical gears with tooth profiles in accordance with the basic rack specified in ISO 53. They are also applicable for teeth conjugate to other basic racks where the virtual contact ratio is less than ε<down αn> = 2,5. The results are in good agreement with other methods for normal working pressure angles up to 25°, reference helix angles up to 25° and in cases where pitch line velocity is higher than 2 m/s.
This part of ISO/TR 15144 is not applicable for the assessment of types of gear tooth surface damage other than micropitting.
文件格式：PDF
文件大小：1.87MB
文件页数：64
（以上信息更新时间为：2019-11-22）
ISO_TR 15144-1-2010 圆柱正齿轮和斜齿轮的微点蚀承载能力计算.第1部分_简介与基本原理.pdf
(1.87 MB)
|
|
