标准号：ISO 23529-2010
实施状态：作废
中文名称：橡胶.物理试验方法用试样制备和整修的一般规程
英文名称：Rubber - General procedures for preparing and conditioning test pieces for physical test methods
发布日期：2010-10
实施日期：2010-10-15
被替代标准：ISO 23529-2016
代替标准：ISO 23529-2004;ISO/FDIS 23529-2010
采用标准：BS ISO 23529-2010,IDT;NF T40-025-2010,IDT
起草单位：ISO/TC 45
标准简介：WARNING — Persons using this International Standard should be familiar with normal laboratory
practice. This standard does not purport to address all of the safety problems, if any, associated with
its use. It is the responsibility of the user to establish appropriate safety and health practices and to
ensure compliance with any national regulatory conditions.
CAUTION — Certain procedures specified in this International Standard can involve the use or
generation of substances, or the generation of waste, that could constitute a local environmental
hazard. Reference should be made to appropriate documentation on safe handling and disposal after use.
This International Standard specifies general procedures for the preparation, measurement, marking, storage,
and conditioning of rubber test pieces for use in physical tests specified in other International Standards, and
the preferred conditions to be used during the tests. Special conditions, applicable to a particular test or
material or simulating a particular climatic environment, are not included, nor are special requirements for
testing whole products.
This International Standard also specifies the requirements for the time interval to be observed between
forming and testing of rubber test pieces and products. Such requirements are necessary to obtain
reproducible test results and to minimize disagreements between customer and supplier.
文件格式：PDF
文件大小：206.29KB
文件页数：22
（以上信息更新时间为：2019-11-22）
ISO 23529-2010 橡胶.物理试验方法用试样制备和整修的一般规程.pdf
(206.29 KB)
|
|
