标准号：ISO 4995-2008
实施状态：作废
中文名称：结构改进的热轧薄钢板
英文名称：Hot-rolled steel sheet of structural quality
发布日期：2008-08
被替代标准：ISO 4995-2014
代替标准：ISO 4995-2001;ISO/DIS 4995-2007
起草单位：ISO/TC 17
标准简介：1.1 This International Standard applies to hot-rolled steel sheet of structural quality in the grades and
classes listed in Table 1, usually prepared without the use of microalloying elements. The product is intended
for structural purposes where particular mechanical properties are required. It is generally used in the
delivered condition and is intended for bolted, dveted or welded structures. This product is produced on a wide
strip mill not a plate mill.
1.2 This product is commonly produced in thicknesses from 1,6 mm to 6 mm and in widths of 600 mm and
over, in coils and cut lengths.
1.3 Hot-rolled sheet less than 500 mm wide may be slit from wide sheet and will be considered as sheet.
NOTE Hot-rolled sheet up to but not including 3 mm in thickness is commonly known as =sheer. Hot-rolled sheet
3 mm and over in thickness is commonly known as either "sheet" or "plate'
1.4 This International Standard does not cover steels intended for boilers or pressure vessels, steels
designated as commercial quality or drawing quality (covered in ISO 357311]), steels to be re-rolled to
cold-reduced products, or steels designated as weathering steels, having increased atmospheric corrosion
resistance.
文件格式：PDF
文件大小：173.69KB
文件页数：14
（以上信息更新时间为：2019-11-22）
ISO 4995-2008 结构改进的热轧薄钢板.pdf
(173.69 KB)
|
|
