标准号：ISO 10110-5-2007
实施状态：作废
中文名称：光学和光子学.光学元件和系统制图准备.第5部分:表面形状公差
英文名称：Optics and photonics - Preparation of drawings for optical elements and systems - Part 5: Surface form tolerances
发布日期：2007-08
被替代标准：ISO 10110-5-2015
代替标准：ISO 10110-5-1996;ISO/DIS 10110-5-2006;ISO 10110-5 Technical Corrigendum 1-1996
采用标准：DIN ISO 10110-5-2008,IDT;DIN ISO 10110-5-2008,IDT;BS ISO 10110-5-2007,IDT;GB/T 2831-2009,NEQ;NF S10-008-5-2008,IDT;JIS B 0090-5-2010,IDT
起草单位：ISO/TC 172
标准简介：ISO 10110 specifies the presentation of design and functional requirements for optical elements and systems
in technical drawings used for manufacturing and inspection.
This part of ISO 10110 specifies rules for indicating the tolerance for surface form.
NOTE 1 The terminology of interferometry is used for the specification of tolerances and, in particular, for the units in
which the tolerances are to be specified; however, this does not stipulate that only interferometric methods may be used
for the actual testing of optical parts. Other non-interferometric methods may be used if the results are converted to the
units specified here.
This part of ISO 10110 applies to surfaces of both spherical and aspheric form.
NOTE 2 ISO 10110-12 allows the surface form tolerance for aspheric surfaces to be specified without reference to this
part of ISO 10110.
文件格式：PDF
文件大小：155.57KB
文件页数：12
（以上信息更新时间为：2019-11-22）
ISO 10110-5-2007 光学和光子学.光学元件和系统制图准备.第5部分_表面形状公差.pdf
(155.57 KB)
|
|
