标准号：ISO 2409-2007
实施状态：作废
中文名称：涂料和清漆.划格试验
英文名称：Paints and varnishes - Cross-cut test
发布日期：2007-05
被替代标准：ISO 2409-2013
代替标准：ISO 2409-1992;ISO/FDIS 2409-2006
采用标准：DIN EN ISO 2409-2007,IDT;BS EN ISO 2409-2007,IDT;EN ISO 2409-2007,IDT;NF T30-038-2007,IDT;SN EN ISO 2409-2007,IDT;OENORM EN ISO 2409-2007,IDT;PN-EN ISO 2409-2007,IDT;PN-EN ISO 2409-2008,IDT;UNE-EN ISO 2409-2007,IDT
起草单位：ISO/TC 35
标准简介：This International Standard describes a test method for assessing the resistance of paint coatings to
separation from substrates when a right-angle lattice pattern is cut into the coating, penetrating through to the
substrate. The property measured by this empirical test procedure depends, among other factors, on the
adhesion of the coating to either the preceding coat or the substrate. This procedure is not to be regarded,
however, as a means of measuring adhesion.
Where a measurement of adhesion is required, attention is drawn to the method described in ISO 4624.
NOTE 1 Although the test is primarily intended for use in the laboratory, the test is also suitable for field testing.
The method described may be used either as a pass/fail test or, where circumstances are appropriate, as a
six-step classification test. When applied to a multi-coat system, assessment of the resistance to separation of
individual layers of the coating from each other may be made.
The test can be carried out on finished objects and/or on specially prepared test specimens.
Although the method is applicable to paint on hard (e.g. metal) and soft (e.g. wood and plaster) substrates,
these different substrates need a different test procedure (see Clause 6).
The method is not suitable for coatings of total thickness greater than 250 μm or for textured coatings.
NOTE 2 The method, when applied to coatings designed to give a rough patterned surface, will give results which will
show too much variation (see also ISO 16276-2).
文件格式：PDF
文件大小：228.75KB
文件页数：16
（以上信息更新时间为：2019-11-22）
ISO 2409-2007 涂料和清漆.划格试验.pdf
(228.75 KB)
|
|
