标准号：ISO 14590-2005
实施状态：作废
中文名称：高抗拉强度、低屈服点、增强成型性冷轧薄钢板
英文名称：Cold-reduced steel sheet of high tensile strength and low yield point with improved formability
发布日期：2005-02
被替代标准：ISO 14590-2016
代替标准：ISO 14590-1999;ISO/DIS 14590-2003
采用标准：DIN EN 10268-2003,MOD
起草单位：ISO/TC 17
标准简介：1.1 This International Standard applies to killed cold-reduced steel sheet of two types that are commercially
available in the world. Type 1 (Table 1) represents steels that are produced to mechanical properties only and
Type 2 (Table 2) are produced to both mechanical and chemical properties. Bake hardening steels are
included in both types. All these steels are commonly produced by continuous annealing.
1.2 Cold-reduced sheet less than 600 mm wide may be slit from wide sheet and will be considered as sheet.
1.3 This International Standard does not cover steels designated as commercial quality or drawing qualities
(covered in ISO 3574), steels of structural quality (covered in ISO 4997) or steels of higher strength with
improved formability (covered in ISO 13887).
文件格式：PDF
文件大小：192.41KB
文件页数：18
（以上信息更新时间为：2019-11-22）
ISO 14590-2005 高抗拉强度、低屈服点、增强成型性冷轧薄钢板.pdf
(192.41 KB)
|
|
