标准号：ISO/TS 17892-6-2004
实施状态：现行
中文名称：土工勘查和检验.土壤的实验室检验.第6部分:落锥体试验
英文名称：Geotechnical investigation and testing - Laboratory testing of soil - Part 6: Fall cone test
发布日期：2004-10
被替代标准：ISO 17892-6-2017
采用标准：DIN ISO/TS 17892-6-2005,IDT;BS DD CEN ISO/TS 17892-6-2010,IDT;CEN ISO/TS 17892-6-2004,IDT;prCEN ISO/TS 17892-6-2003,IDT;CEN ISO/TS 17892-6/AC-2005,IDT;XP P94-512-6-2005,IDT;OENORM CEN ISO/TS 17892-6-2005,IDT;PKN-CEN ISO/TS 17892-6-2009,IDT
起草单位：ISO/TC 182
标准简介：This document specifies the laboratory determination of undrained shear strength of both undisturbed and remoulded specimen of saturated fine grained cohesive soils by use of a fall-cone.
This document specifies the fall-cone test, in which a cone is allowed to fall with its tip towards a soil specimen, whereupon the penetration of the cone into the soil is measured. Tests performed according to this test yield penetration values which can be used to estimate the undrained shear strength.
The test is applicable to both undisturbed and remoulded soil test specimen.
For undisturbed soil test specimen, the results of the test are dependent on the quality of the specimen. Because of possible effects of anisotropy, it can also differ depending on what undrained shear strength the relation refers to.
The evaluated value of the undrained shear strength of the 'undisturbed' soil refers to its state during the test in the laboratory. This value is not necessarily indicative of the undrained shear strength of the soil in its natural state in the field. Therefore, the test should be regarded as an index test.
NOTE 1 For non-homogeneous soil samples, this method yields values of the undrained shear strength which are less representative for the bulk shear strength of the sample than other tests involving a larger volume of soil.
NOTE 2 For disturbed soil samples and fissured soil samples this method normally yields higher strength values than tests involving a larger volume of soil.
文件格式：PDF
文件大小：381.50KB
文件页数：18
（以上信息更新时间为：2019-11-22）
ISO_TS 17892-6-2004 土工勘查和检验.土壤的实验室检验.第6部分_落锥体试验.pdf
(381.5 KB)
|
|
