标准号：ISO 4126-6-2003
实施状态：作废
中文名称：过压保护安全设备.第6部分:防爆板安全设备的应用、选择和安装
英文名称：Safety devices for protection against excessive pressure - Part 6: Application, selection and installation of bursting disc safety devices
发布日期：2003-12
被替代标准：ISO 4126-6-2014
代替标准：ISO/FDIS 4126-6-2002;ISO 6718-1991;ISO 6718 Technical Corrigendum 1-1993
采用标准：DIN EN ISO 4126-6-2004,IDT;DIN EN ISO 4126-6-2001,IDT;BS EN ISO 4126-6-2004,IDT;EN ISO 4126-6-2003,IDT;NF E29-417-6-2004,IDT;SN EN ISO 4126-6-2004,IDT;OENORM EN ISO 4126-6-2004,IDT;PN-EN ISO 4126-6-2005,IDT;UNE-EN ISO 4126-6-2004,IDT
起草单位：ISO/TC 185
标准简介：This standard gives guidance on the application, selection and installation of bursting disc safety devices used to protect pressure equipment from excessive pressure and/or excessive vacuum.
Annex A provides a checklist for the information to be supplied by the purchaser to the manufacturer.
Annex B gives guidance on the replacement period of a bursting disc and annex C guidance on determining the mass flow rate, for single phase fluids, of a pressure relief system that contains a bursting disc safety device
Annex E is a non-mandatory procedure for establishing the flow resistance of a burst bursting disc assembly.
The requirements for the manufacture, inspection, testing, marking, certification and packaging of bursting disc safety devices are given in Part 2 of EN ISO 4126.
文件格式：PDF
文件大小：466.43KB
文件页数：40
（以上信息更新时间为：2019-11-22）
ISO 4126-6-2003 过压保护安全设备.第6部分_防爆板安全设备的应用、选择和安装.pdf
(466.43 KB)
|
|
