标准号：ISO 15876-2-2003
实施状态：作废
中文名称：冷热水装置用塑料管道系统.聚丁烯(PB).第2部分:管道
英文名称：Plastics piping systems for hot and cold water installations - Polybutylene (PB) - Part 2: Pipes
发布日期：2003-12
被替代标准：ISO 15876-2-2017
代替标准：ISO/FDIS 15876-2-2002
采用标准：DIN EN 12319-2-1996,IDT;DIN EN ISO 15876-2-2004,IDT;BS EN ISO 15876-2-2004,IDT;EN ISO 15876-2-2003,IDT;NF T54-944-2-2004,IDT;JIS K 6778-2004,MOD;JIS K 6792-2004,MOD;SN EN ISO 15876-2-2004,IDT;OENORM EN ISO 15876-2-2004,IDT;OENORM EN ISO 15876-2-2008,IDT;OENORM EN ISO 15876-2/A1-2006,IDT;PN-EN ISO 15876-2-2004,IDT;PN-EN ISO 15876-2-2009,IDT;UNE-EN ISO 15876-2-2004,IDT
起草单位：ISO/TC 138
标准简介：This Part of EN ISO 15876 specifies the characteristics of pipes made of polybutylene (PB) for piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water whether or not intended for human consumption (domestic systems), and for heating systems, under design pressures and temperatures appropriate to the class of application (see Table 1 of EN ISO 15876-1:2003).
This standard covers a range of service conditions (application classes), design pressures and pipe dimension classes. For values of TD, Tmax and Tmal in excess of those in Table 1 of Part 1, this standard does not apply.
NOTE 1 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.
It also specifies the test parameters for the test methods referred to in this standard.
In conjunction with the other Parts of EN ISO 15876 (see Foreword) it is applicable to PB pipes, their joints and to joints with components of PB, other plastics and non-plastics materials intended to be used for hot and cold water installations.
It is applicable to pipes with or without (a) barrier layer(s).
NOTE 2 In the case of plastics pipes provided with a thin barrier layer, e.g. to prevent or greatly diminish the diffusion of gases and the transmission of light into or through the pipe wall and where the design stress requirements are totally met by the base polymer (PB).
文件格式：PDF
文件大小：120.82KB
文件页数：6
（以上信息更新时间为：2019-11-22）
ISO 15876-2-2003 冷热水装置用塑料管道系统.聚丁烯(PB).第2部分_管道.pdf
(120.82 KB)
|
|
