标准号：ISO/TS 29001-2003
实施状态：作废
中文名称：石油、化工和天然气工业.部门专用质量管理系统.产品和服务机构的要求
英文名称：Petroleum, petrochemical and natural gas industries - Sector-specific quality management systems - Requirements for product and service supply organizations
发布日期：2003-09
被替代标准：ISO/TS 29001-2007
采用标准：FD M87-200-2005,IDT
起草单位：ISO/TC 67
标准简介：1 General
ISO 9001:2000, Quality management systems — Requirements Introduction
1.1 General
This International Standard specifies requirements for a quality management system where an organization
a) needs to demonstrate its ability to consistently provide product that meets customer and applicable regulatory requirements, and
b) aims to enhance customer satisfaction through the effective application of the system, including processes for continual improvement of the system and tie assurance of conformity to customer and applicable regulatory requirements.
NOTE In this International Standard, the term "product" applies only to the product intended for, or required by, a customer.
This Technical Specification defines the quality management system requirements for the design, development, production, installation and service of products for the petroleum, petrochemical and natural gas industries.
2 Application
ISO 9001:2000, Quality management systems — Requirements
1.2 Application
All requirements of this International Standard are generic and are intended to be applicable to all organizations, regardless of type, size and product provided.
Where any requirement(s) of this International Standard cannot be applied due to the nature of an organization and its product, this can be considered for exclusion.
Where exclusions are made, claims of conformity to this International Standard are not acceptable unless these exclusions are limited to requirements within clause 7, and such exclusions do not affect the organization's ability, or responsibility, to provide product that meets customer and applicable regulatory requirements.
2.1 Application — Supplemental
Where exclusions are made, claims of conformity to this Technical Specification are not acceptable unless these exclusions are limited to requirements within the subclauses listed below in this subclause, and such exclusions do not affect the organization's ability, or responsibility, to provide product that meets customer and applicable regulatory requirements:
7.3 Design and development
7.5.1 Control of service provision
7.5.2 Validation of processes for production and service provision
7.5.4 Customer property
NOTE The exclusion to 7.5.2 only applies to the supplemental requirement of 7.5.2.1.
文件格式：PDF
文件大小：1.53MB
文件页数：38
（以上信息更新时间为：2019-11-23）
ISO_TS 29001-2003 石油、化工和天然气工业.部门专用质量管理系统.产品和服务机构的要求.pdf
(1.53 MB)
|
|
