ISO 7919-2-2001 机械振动 用旋转轴的测量评定机械振动 第2部分:功率超过50MW、额定转速在1500r/min、1800 r/min、3000 r/min和3600 r/min的陆地安装的汽轮发电机组

[复制链接]
查看1329 | 回复5 | 2018-5-13 12:35 | 显示全部楼层 |阅读模式
标准号:ISO 7919-2-2001
实施状态:作废
中文名称:机械振动  用旋转轴的测量评定机械振动  第2部分:功率超过50MW、额定转速在1500r/min、1800 r/min、3000 r/min和3600 r/min的陆地安装的汽轮发电机组
英文名称:Mechanical vibration - Evaluation of machine vibration by measurements on rotating shafts - Part 2: Land-based steam turbines and generators in excess of 50 MW with normal operating speeds of 1500 r/min, 1800 r/min, 3000 r/min and 3600 r/min
发布日期:2001-11
被替代标准:ISO 7919-2-2009
代替标准:ISO 7919-2-1996;ISO/FDIS 7919-2-2001
采用标准:DIN ISO 7919-2-2002,IDT;BS ISO 7919-2-2002,IDT;NF E90-079-2-2002,IDT;GOST R ISO 18436-2-2005,MOD
起草单位:ISO/TC 108
标准简介:This part of ISO 7919 gives guidelines for applying evaluation criteria for shaft vibration measured in the radial direction at or close to the bearings of steam turbines and generators. These guidelines are presented in terms of:
—  vibration under normal steady-state operating conditions;
—  vibration during transient operation, including passage through resonant speeds during run up or run down;
—  changes in vibration which can occur during normal steady-state operation.
The numerical values specified are not intended to serve as the only basis for vibration evaluation since, in general as described in the introduction to ISO 7919-1, the vibratory condition of a machine is assessed by consideration of both the shaft vibration and the associated structural vibration (see ISO 10816-2).
This part of ISO 7919 is applicable to land-based steam turbines and generators with a normal operating speed of 1 500 r/min, 1 800 r/min, 3 000 r/min or 3 600 r/min, and power outputs greater than 50 MW. It also includes steam turbines and/or generators which are directly coupled to a gas turbine (such as for combined cycle applications). In such cases the criteria of this part of ISO 7919 apply only to the steam turbine and the generator. Evaluation of the gas turbine vibration should be carried out in accordance with ISO 7919-4 and ISO 10816-4.
文件格式:PDF
文件大小:126.21KB
文件页数:16
(以上信息更新时间为:2019-11-23)

ISO 7919-2-2001 机械振动 用旋转轴的测量评定机械振动 第2部分:功率超过50MW、额定转速在1500r_min、1800 r_min、3000 r_min和3600 r_min的陆地安装的汽轮发电机组.pdf (126.21 KB)

使用道具 举报