标准号：ISO 10300-1-2001
实施状态：作废
中文名称：斜齿轮承载能力的计算 第1部分：引言和一般影响因素
英文名称：Calculation of load capacity of bevel gears - Part 1: Introduction and general influence factors
发布日期：2001-08
被替代标准：ISO 10300-1-2014
代替标准：ISO/FDIS 10300-1-2000
采用标准：DIN 3991-1-1988,MOD;94/710465 DC-1994,IDT;BS ISO 10300-1-2001,IDT;GB/T 10062.1-2003,IDT;OENORM ISO 10300-1-2006,IDT;OENORM ISO 10300-1-2005,IDT
起草单位：ISO/TC 60
标准简介：The formulae in ISO 10300 are intended to establish uniformly acceptable methods for calculating the pitting resistance and bending-strength capacity of straight and helical (skew), zerol and spiral bevel gears except hypoid gears. They are applicable equally to tapered depth and uniform depth teeth.
The formulae take into account the known major factors influencing gear-tooth pitting and fractures at the root fillet, as well as allowing for the inclusion of new factors at a later date. The rating formulae are not applicable to other types of gear-tooth deterioration such as plastic yielding, micropitting, case crushing, welding, and wear. The bending-strength formulae are applicable to fractures at the tooth fillet, but not to those on the tooth-working profile surfaces, nor to failure of the gear rim or of the gear blank through the web and hub. Pitting resistance and bending-strength capacity rating systems for a particular category of bevel gear can be established by selecting proper values for the factors used in the general formulae. ISO 10300 is not applicable to bevel gears which have an inadequate contact pattern.
ISO 10300 is restricted to bevel gears whose virtual cylindrical gears have transverse contact ratios of εvα < 2. The given relations are valid for gears of which the sum of addendum modification factors of pinion and gear is zero, i.e. the normal operating pressure angle of the gear pair is the same as the normal pressure angle of the basic rack.
NOTE Methods for the calculation of the load capacity of hypoid gears are indicated by the manufacturers of gear-cutting machines.
CAUTION — The user is cautioned that when the methods are used for large spiral and pressure angles, and for large face width b > 10 mmn, the calculated results of ISO 10300 should be confirmed by experience.
文件格式：PDF
文件大小：675.49KB
文件页数：56
（以上信息更新时间为：2019-11-23）
ISO 10300-1-2001 斜齿轮承载能力的计算 第1部分：引言和一般影响因素.pdf
(675.49 KB)
|
|
