标准号：ISO 10360-5-2000
实施状态：作废
中文名称：产品几何量技术规范(GPS) 坐标测量机(CMM)的验收和复检试验 第5部分:使用多触针探测系统的坐标测量机
英文名称：Geometrical Product Specifications (GPS) - Acceptance and reverification tests for coordinate measuring machines (CMM) - Part 5: CMMs using multiple-stylus probing systems
发布日期：2000-12
被替代标准：ISO 10360-5-2010
代替标准：ISO/FDIS 10360-5-2000
采用标准：DIN EN ISO 10360-5-2001,IDT;BS EN ISO 10360-5-2001,IDT;GB/T 16857.5-2004,IDT;EN ISO 10360-5-2000,IDT;NF E11-150-5-2001,IDT;JIS B 7440-5-2004),IDT;SN EN ISO 10360-5-2001,IDT;OENORM EN ISO 10360-5-2001,IDT;PN-EN ISO 10360-5-2003,IDT;UNE-EN ISO 10360-5-2001,IDT
起草单位：ISO/TC 213
标准简介：This part of ISO 10360 specifies acceptance and periodic reverification tests of the performance of CMMs having multiple-stylus probing systems, including systems with fixed multiple-styli attached to a single probe (e.g. "star" stylus), multiple-probing systems such as those with a stylus for each of their probes, and systems with articulating probing.
The acceptance test and reverification test specified in this part of ISO 10360 are applicable only to the following:
— CMMs using any type of contact-probing system;
— stylus system configurations able to be prequalified (i.e. where the repeatability of the system operation is sufficient so that a stylus qualification is not required for each use);
NOTE In the case of prequalified configurations, a similar test could be devised for non-repeatable changes of stylus system configurations.
— spherical, hemispherical and disk-shaped styli.
These tests are not applicable to non-contact probing systems, which require special testing procedures outside the scope of this part of ISO 10360.
文件格式：PDF
文件大小：103.57KB
文件页数：20
（以上信息更新时间为：2019-11-23）
ISO 10360-5-2000 产品几何量技术规范(GPS) 坐标测量机(CMM)的验收和复检试验 第5部分_使用多触针探测系统的坐标测量机.pdf
(103.57 KB)
|
|
