标准号：ISO 15103-1-2000
实施状态：作废
中文名称：塑料 聚苯撑醚(PPE)模塑和挤塑材料 第1部分:命名系统和基本规范
英文名称：Plastics - Poly(phenylene ether) (PPE) moulding and extrusion materials - Part 1: Designation system and basis for specifications
发布日期：2000-07
被替代标准：ISO 28941-1-2008
代替标准：ISO/FDIS 15103-1-1999
采用标准：DIN EN ISO 15103-1-2004,IDT;DIN EN ISO 15103-1-2004,IDT;BS EN ISO 15103-1-2004,IDT;EN ISO 15103-1-2004,IDT;prEN ISO 15103-1-2003,IDT;NF T53-051-1-2005,IDT;T53-051-1PR,IDT;JIS K 7313-1-2008,MOD;SN EN ISO 15103-1-2004,IDT;OENORM EN ISO 15103-1-2004,IDT;OENORM EN ISO 15103-1-2004,IDT;PN-EN ISO 15103-1-2005,IDT;PN-EN ISO 15103-1-2007,IDT;UNE-EN ISO 15103-1-2005,IDT
起草单位：ISO/TC 61
标准简介：1 This part of ISO 15103 establishes a system of designation for PPE thermoplastic materials, which may be used as the basis for specifications.
2 The types of PPE plastic are differentiated from each other by a classification system based on appropriate lev-els of the designatory properties
a) temperature of deflection under load
b) Charpy notched impact strength
c) flammability
and on information about basic polymer parameters, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials.
3 This part of ISO 15103 is applicable to all PPE materials, including those modified with polystyrene or poly-amide or other materials.
It applies to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc.
4 It is not intended to imply that materials having the same designation give necessarily the same performance. This part of ISO 15103 does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application and/or method of processing.
If such additional properties are required, they shall be determined in accordance with the test methods specified in part 2 of this International Standard, if suitable.
5 In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements may be given in data block 5 (see 3.1).
文件格式：PDF
文件大小：283.02KB
文件页数：14
（以上信息更新时间为：2019-11-23）
ISO 15103-1-2000 塑料 聚苯撑醚(PPE)模塑和挤塑材料 第1部分_命名系统和基本规范.pdf
(283.02 KB)
|
|
