标准号：IEC 60793-1-42-2007
实施状态：作废
中文名称：光纤.第1-42部分:测量方法和试验程序.色散
英文名称：Optical fibres - Part 1-42: Measurement methods and test procedures - Chromatic dispersion
发布日期：2007-06
被替代标准：IEC 60793-1-42-2013
代替标准：IEC 86A/1136/FDIS-2007;IEC 60793-1-42-2001;IEC 60793-1-42 Corrigendum 1-2007
采用标准：DIN EN 60793-1-42-2008,IDT;BS EN 60793-1-42-2007,IDT;EN 60793-1-42-2007,IDT;PN-EN 60793-1-42-2007,IDT
起草单位：IEC/SC 86A
标准简介：This part of IEC 60793 establishes uniform requirements for measuring the chromatic dispersion of optical fibre, thereby assisting in the inspection of fibres and cables for commercial purposes.
Chromatic dispersion varies with wavelength. Some methods and implementations measure the group delay as a function of wavelength and the chromatic dispersion and dispersion slope are deduced from the derivatives (with respect to wavelength) of this data. This differentiation is most often done after the data are fitted to a mathematical model. Other implementations can allow direct measurement (of the chromatic dispersion) at each of the required wavelengths.
For some categories of fibre, the chromatic dispersion attributes are specified with the parameters of a specific model. In these cases, the relevant recommendation or standard defines the model appropriate for the definition of the specified parameters, For other fibre categories, the dispersion is specified to be within a given range for one or more specified wavelength intervals. In the latter case, either direct measurements may be made at the wavelength extremes or some fitting model may be used to allow either group delay measurement methods or implementations or storage of a reduced set of parameters that may be used to calculate the interpolated dispersion for particular wavelengths which may not have actual direct measurement values.
Annex E gives a general description of chromatic dispersion fitting and outlines a number of fitting equations suitable for use with any of the measurement methods or fibre categories.
This standard gives four methods for measuring chromatic dispersion:
- method A: phase shift;
- method B: spectral group delay in the time domain;
- method C: differential phase shift;
- method D: interferometry.
Methods A, B, and C apply to the measurement of chromatic dispersion of the following fibres over a specified wavelength range:
- class A1 graded-index multimode fibres;
- category A4f, A4g and A4h multimode fibres;
- class B single-mode fibres (all categories).
Method D applies to the measurement of chromatic dispersion values of single-mode fibres categories B1, B2, B4 and B5 over the 1 000 nm to 1 700 nm wavelength range.
The methods can be applied to laboratory, factory and field measurements of chromatic dispersion, and the wavelength range of the measurements can be tailored as required. Measurements are made at temperature as stated in IEC 60793-1-1, Table 1 - Standard range of atmospheric conditions (Temperature 23 °C ±5 °C).
The methods are suitable for fibre or cable lengths greater than 1 km. They may also be applied to shorter lengths, but accuracy and repeatability may be compromised. Method D is the preferred method for shorter piece fibres (1 m to 10 m).
Information common to all methods is contained in Clauses 1-8, and information pertaining to each individual method appears in Annexes A, B, C, and D, respectively.
文件格式：PDF
文件大小：516.40KB
文件页数：68
（以上信息更新时间为：2019-11-25）
标准全文下载：
IEC 60793-1-42-2007 光纤.第1-42部分_测量方法和试验程序.色散.pdf
(516.4 KB)
|
|
