标准号：ISO 4666-3-2010
实施状态：作废
中文名称：硫化橡胶.挠度计测试中温升和抗疲劳性的测定.第3部分:压缩式挠度计(恒张力式)
英文名称：Rubber, vulcanized - Determination of temperature rise and resistance to fatigue in flexometer testing - Part 3: Compression flexometer (constant-strain type)
发布日期：2010-10-01
实施日期：2010-10-01
被替代标准：ISO 4666-3-2016
代替标准：ISO 4666-3-1982;ISO/DIS 4666-3-2009
采用标准：BS ISO 4666-3-2010,IDT
起草单位：ISO/TC 45
标准简介：WARNING — Persons using this International Standard should be familiar with normal laboratory
practice. This standard does not purport to address all of the safety problems, if any, associated with
its use. It is the responsibility of the user to establish appropriate safety and health practices and to
ensure compliance with any national regulatory conditions.
CAUTION — Certain procedures specified in this International Standard may involve the use or
generation of substances, or the generation of waste, that could constitute a local environmental
hazard. Reference should be made to appropriate documentation on safe handling and disposal after use.
This part of ISO 4666 specifies the flexometer test with constant-strain amplitude for the determination of the
temperature rise and resistance to fatigue of vulcanized rubber. The flexometer specified is known as the
Goodrich flexometer, but any other apparatus giving equivalent performance can be used.
This part of ISO 4666 gives directions for carrying out measurements which make possible predictions
regarding the durability of rubbers in finished articles subject to dynamic flexing in service such as tyres,
bearings, supports, V-belts, and cable-pulley insert rings. However, owing to the wide variations in service
conditions, no simple correlation between the accelerated tests described in the various parts of this
International Standard and service performance can be assumed.
The method is not recommended for rubber having a hardness greater than 85 IRHD.
文件格式：PDF
文件大小：259.66KB
文件页数：22
（以上信息更新时间为：2019-11-22）
ISO 4666-3-2010 硫化橡胶.挠度计测试中温升和抗疲劳性的测定.第3部分_压缩式挠度计(恒张力式).pdf
(259.66 KB)
|
|
