标准号：ISO 1641-1-2003
实施状态：作废
中文名称：端铣刀和槽铣刀.第1部分:直柄铣刀
英文名称：End mills and slot drills - Part 1: Milling cutters with cylindrical shanks
发布日期：2003-06
被替代标准：ISO 1641-1-2016
代替标准：ISO 1641-1-1978;ISO/FDIS 1641-1-2002
采用标准：BS ISO 1641-1-2003,IDT;NF E66-215-1-2003,IDT;GOST R 53002-2008,IDT;GOST R 53003-2008,IDT
起草单位：ISO/TC 29
标准简介：This part of ISO 1642 specifies the general dimensions of the following milling cutters with plain cylindrical, flatted cylindrical and threaded shanks:
— end mills, flat-ended or ball-nosed — standard series and long series;
— slot drills — short series and standard series.
The dimensional characteristics of cylindrical shanks are in accordance with ISO 3338-1, ISO 3338-2 and ISO 3338-3.
NOTE These same milling cutters with Morse taper shanks having a tapped hole are dealt with in ISO 1641-2, those with 7/24 taper shanks in ISO 1641-3.
This part of ISO 1641 does not apply to solid hardmetal end mills and slot drills.
文件格式：PDF
文件大小：164.20KB
文件页数：10
（以上信息更新时间为：2019-11-23）
ISO 1641-1-2003 端铣刀和槽铣刀.第1部分_直柄铣刀.pdf
(164.2 KB)
|
|
